SEAL-O-RING 5P2545 - Caterpillar

The ends of the bellows are very sharp. Injury could occur if the bellows are not handled properly. Handle the bellows by the convolutions.
The alignment of the bellows is important. Improper alignment may lead to premature failure of the bellows. Misalignment can be identified by visually inspecting the convolutions for uniformity of compression.Inspect the bellows for damage prior to installation. If there is any damage to the convolutions, discard the bellows. Minor damage to the ends of the bellows may be repaired. However, if there is any difficulty in installation after the repair, discard the bellows.
Illustration 1 g01105367
(1) Torque for bands (1) on inlet for precooler ... 12 2 N m (105 18 lb in) (2) Precooler
Illustration 2 g01323049
View A-A (3) Center line of the crankshaft (A) The orientation of the bolt must be 0 10 degrees with respect to centerline (3). (B) The orientation of the bolt must be 0 10 degrees with respect to centerline (3).
Illustration 3 g01008774
(4) Torque for bands ... 12 2 N m (105 18 lb in)
Illustration 4 g01323011
Orientation of bands C ... 45 5 degrees D ... 95 10 degrees E ... 30 5 degrees F ... 90 5 degrees
Illustration 5 g01008778
(5) Torque for band on outlet for precooler ... 12 2 N m
(105 18 lb in)