SEAL (use as required) 5P5961 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty.
A 439-3938 Link Bracket 4 Start By:
Remove the rocker shaft and pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Remove".
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates.
Note: Repeat the procedure for each cylinder head.
Drain the coolant into a suitable container for storage or disposal.
Illustration 1 g06161512
If there is a support (2) attached to the valve cover base, remove bolts (1) and set out of the way.
Illustration 2 g06161514
Remove exhaust temperature sensor (3) and set out of the way.
Remove the bolts (4) from the valve cover base (5) and remove from the cylinder head.
Illustration 3 g06161517
Remove bolts (6) and remove water tube assembly (7).
Illustration 4 g06161520
Remove bolts (8) from the air inlet elbow (9).
Remove bolts (10) from the exhaust elbow (11).
Illustration 5 g06161636
Install Tooling (A) on cylinder head (14). Use the holes for the bolts that hold the valve cover base. The cylinder head (14) weighs approximately 41 kg (90 lb).
Fasten a suitable lifting device to the cylinder head (14).
Remove bolts (12), (13), and (15) and set the brackets out of the way.
Remove the cylinder head (14) from the engine.