SEAL-RECTANGULAR 5P7085 - Caterpillar

Introduction
The TA19 transmission provides 16 forward gears and 4 reverse gears.There is nine individual clutch packs on five transmission shafts. Each clutch pack is controlled by a corresponding modulating valve (transmission). The transmission electronic control module (ECM) controls the modulating valve. The modulating valve will modulate the oil pressure and flow in order to provide smooth shifting between gears.The transmission hydraulic system has the following main components:
Sump
Charge pump
Relief valve (charge pressure)
Modulating valves (transmission)
Electronic controlsSump
The sump provides oil for the transmission hydraulic system.Charge Pump
The charge pump provides pressurized oil to the transmission hydraulic system. The oil flow from this pump is continuous and the pressure is constant after the engine is started.Relief Valve (Charge Pressure)
The relief valve (charge pressure) controls the oil pressure to 2100 kPa (305 psi).Modulating Valves (Transmission)
The transmission is equipped with nine modulating valves. The modulating valves are controlled by the use of electronics. Nine modulating valves provide oil to the transmission clutches. There are nine corresponding transmission clutches.Electronic Controls
The transmission ECM controls the solenoids on the modulating valves (transmission).Transmission Hydraulic System
The transmission hydraulic system provides a modulated flow of pressurized oil to the transmission. The transmission contains nine transmission clutches. The nine clutches are controlled by the nine corresponding modulating valves (transmission). The transmission provides the operator with 16 forward and 4 reverse gears.The modulating valves (transmission) provide the following control functions:
Proportional control of pressure
Controls oil flow to clutchTransmission Electrical System
The transmission electrical system provides controls for the transmission hydraulic system. The transmission electrical system includes switches, sensors, and control levers. The inputs signals are processed by the transmission electronic control module (ECM) which then energizes the appropriate solenoid.The transmission electrical system contains the following components:
Transmission ECM
Control inputs
SolenoidsThe transmission hydraulic system provides a modulated flow of pressurized oil to the transmission. The transmission contains nine transmission clutches. The nine clutches are controlled by the nine corresponding modulating valves (transmission). The transmission provides the operator with 16 forward and 4 reverse gears.