SEAL 5P8292 - Caterpillar

Illustration 1 g02025266
Schematic of Action alarm and "Monitor" module
This diagnostic code is recorded when the "Monitor" module determines that the current of the action alarm is above normal. The "Monitor" module indicates the fault to the Machine ECM over the CAN Data Link. The possible causes of this diagnostic code are listed below:
The energize circuit of the action alarm is shorted to ground.
The action alarm has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0271 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK THE ACTION ALARM.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the action alarm with the active diagnostic code from the machine harness. Expected Result:The status of CID 0271 FMI 06 diagnostic code changes when the action alarm is disconnected.Results:
YES - The status of CID 0271 FMI 06 diagnostic code changes when the action alarm is disconnected. The circuit is correct.Repair: The action alarm has failed. Repeat this test "CHECK THE ACTION ALARM" in order to verify the failure of the action alarm. Replace the action alarm.STOP
NO - The CID 0271 FMI 06 diagnostic code remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE ACTION ALARM FOR A SHORT TO GROUND.
Turn the key start switch and the disconnect switch to the OFF position.
The action alarm remains disconnected from the machine harness.
Disconnect the machine harness connector(s) from the ECM.
At the machine harness connector, measure the resistance from the signal contact 12 (wire 410-WH(White)) to all contacts that are used in the connectors of the machine harness for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between contact 12 (wire 410-WH(White)) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness. STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the harness connectors. Clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0271 FMI 06 diagnostic code. Expected Result:The CID 0271 FMI 06 diagnostic code is active. Results:
YES - The CID 0271 FMI 06 diagnostic code is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the "Monitor" module has failed. Exit this procedure and perform this procedure again. Refer to the Electrical System Schematic for this machine