SEAL-O-RING 5W5479 - Caterpillar

Installation Of The 6V2197 Transducer Group And Its Correction Factors
On most 3406, 3408 and 3412 Engines, the 6V2197 Transducer can be installed either on the left side, as one faces the flywheel, or on the right side of the flywheel housing. But, a different correction factor is needed for each installation.
To correctly install the 6V2197 Transducer, it must be approximately 0.5 mm to 2.0 mm (.02" to .08") from the flywheel surface. It is possible for one of the holes to be in alignment with the pin timing opening in the housing. Make sure the transducer is not in one of these holes. If necessary, remove the transducer, turn the flywheel with an engine rotation tool and install the transducer again.
If the transducer is installed on the left side of flywheel housing, the timing indication will be retarded by approximately 7.6°. This is because the transducer reads the first hole it senses as top center after injection for the No. 1 cylinder. As a result, the transducer reads hole "A", shown in the illustration, instead of hole "B".
When the transducer is installed on the right side of the flywheel housing, the 6V3100 Timing Indicator Group will show the correct timing indication until the fuel system advances to approximately 22.4°. At this point, the injection point moves forward of hole "C", and the indication goes to zero because the transducer will read hole "C" instead of hole "D". The indication will again start to increase, but to correct it approximately 22.4° must be added.
Hole pattern in the 6N9667 Flywheel Assembly. This problem is not present on 3306 Engines Used With Allison CT700, HT700, 5000 and 6000 Transmissions or TC500 Series Torque Converters.Service Information
When pin timing the engine on its left side, the pin can slide into any of the 25.4 mm (1.00") holes. For correct timing, it must be installed in the threaded timing hole.
Also, when the 6V3121 Multitach Group and the 6V2197 Transducer are used to measure engine speed, the correct pulses per revolution setting (P/REV) is 13 since the transducer will read the twelve 25.4 mm (1.00") holes and the timing hole during one revolution.