SEAL-O-RING 6I4545 - Caterpillar

System Operation Description:The rack solenoid is used to move the engine fuel rack. The rack solenoid is actuated by a spring to the fuel OFF position. The rack solenoid moves into the ON position when voltage is applied.
Illustration 1 g01643973
Illustration 2 g01643993
(10) + 8 VDC (22) Solenoid ground (23) Rack solenoid (30) + 5 VDC (35) Analog return (40) Rack position
Table 1
Diagnostic Codes Table    
Code and Description    Flash Code    Conditions which Generate this Code    System Response    
23-02 Engine Power Excessive
    48
    The actual rack position is greater than the desired rack position. Excessive power is being generated by the engine.
    The code is logged.    
Factory passwords are required to clear this code.
23-05 Rack BTM current low
    43
    The actual rack position is not proportional to the desired rack position. There are no sensor supply voltage faults. The arm of the rack solenoid is not in the desired position.
    The code is logged.    
The ECM uses the engine speed to govern the engine. The rack sensor signal is ignored. The rack limit is set to
13.5 mm (0.53 inch).
23-06 Rack BTM current high
    43
    The actual rack position is not proportional to the desired rack position. There are no sensor supply voltage faults. The arm of the rack solenoid is not in the desired position.
    The code is logged.    
The ECM uses the engine speed to govern the engine. The rack sensor signal is ignored. The rack limit is set to
13.5 mm (0.53 inch). Test Step 1. Inspect the Electrical Connectors and the Wiring Harness
Remove electrical power from the ECM.
Thoroughly inspect the J6/P6 connector for the rack solenoid (BTM) and the J11/P11 connector for the rack position sensor. Inspect the ECM connector J14/P14. Refer to Troubleshooting, "Electrical Connectors - Inspect" for details.
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the circuit.
Check the allen head screw on the ECM connector for the proper torque. Refer to Troubleshooting, "Electrical Connectors - Inspect" for the correct torque values.Expected Result:All connectors, pins, and sockets are completely coupled and/or inserted, and the harness and wiring are free of corrosion, of abrasion and of pinch points.Results:
OK - All connectors, pins, and sockets are completely coupled and/or inserted, and the harness and wiring are free of corrosion, of abrasion and of pinch points. Proceed to Test Step 2.
NOT OK - There is a problem with the connectors and/or the wiring.Repair: Repair the wiring and connectors or replace the wiring or the connectors. Ensure that all of the seals are properly connected. Verify that the repair eliminates the problem.Verify that the repair eliminates the problem.STOPTest Step 2. Remove the Rack Solenoid and Inspect the Rack Solenoid
Turn the engine control switch to the OFF position.
Remove the rack solenoid.
Make sure that the rack and the rack servo have free movement.
Inspect the arm of the rack solenoid for damage and signs of binding in the sleeve of the servo.Expected Result:The arm of the rack solenoid is