SEAL-O-RING 6J2244 - Caterpillar

Configuration parameters concern various engine features. Some parameters can affect the performance of the engine. Most of the parameters may be programmed with an Electronic Technician (ET) service tool. Some of the parameters require a password in order to be programmed.Note: For information on programming the parameters, use the appropriate ET service tool and see the Service Manual, "Troubleshooting" module.Some parameters may not be available on all applications. If a parameter is not available the ET service tool will indicate that the parameter is "unavailable" when the parameter is selected. Table 1 is a list of typical configuration parameters.
Table 1
Typical Configuration Parameters    
Parameter    Programmability    
"Air Shutoff" (ON/OFF)     Yes    
"CAT Datalink #2 ID"     Yes    
"Crank Duration"     Yes    
"Crank Terminate Speed"     Yes    
"Cold Mode Cylinder Cutout"     Yes    
"Cooldown Speed"     Yes    
"ECM Serial Number"     No    
"Engine Accel. Rate"     Yes    
"Engine Cooldown Duration"     Yes    
"Engine Cooling System Config." (1)     Yes    
"Engine Pre-Lube Duration"     Yes    
"Engine Serial Number"     Yes    
"Equipment ID"     Yes    
"Ether Control" (ON/OFF)     Yes    
"Fuel Correction Factor"     Yes    
"Fuel Ratio Control Offset"     Yes    
"Low Idle Speed"     Yes    
"Maximum No of Crank Cycles"     Yes    
"Personality Module Part Number"     Software dependent    
"Personality Module Release Date"     Software dependent    
"Rated Engine Speed"     Software dependent    
"Rated Fuel Position"     Yes    
"Total Tattletale"     No    
( 1 ) Jacket water aftercooling or separate circuit aftercoolingThe following parameters are programmed at the factory to "0":
"Crank Duration"
"Maximum Number Of Crank Cycles"The "0" settings prevent the Electronic Control Module (ECM) from engaging the starting motors. The settings must be reprogrammed before the engine will crank.Ensure that the "Air Shutoff" and the "Ether Control" parameters are "Enabled/ON" (if equipped). If the engine does not have these options, ensure that these two parameters are "DISABLED/OFF".The engine will have either jacket water aftercooling or separate circuit aftercooling. The correct configuration of the aftercooling system must be programmed.No password is required for programming a new ECM during the first 100 hours of service life. This 100 hour "free configuration" feature enables the customer to tailor the programmable setpoints to the requirements of the installation. Exceptions are "Fuel Limit" and "Personality Module Mismatch".Air Shutoff (If Equipped)
The air shutoff uses a moving plate to block inlet air to the aftercooler. The engine stops because of the restricted air supply to the combustion chamber. The air shutoff only actuates for the following conditions:
The Emergency Stop button is pressed.
An overspeed shutdown occurs.Both of the air shutoffs must be reset before the engine can be restarted.
Illustration 1 g01304979
Reset for the air shutoffTo reset the air shutoff, rotate the hex to the "OPEN" position.Ensure that both of the air shutoffs are reset.Power to the ECM must be cycled in order to restart the engine. Turn the battery disconnect switch to the OFF position for