SEAL-O-RING 6V5142 - Caterpillar

Record the configuration parameters for your scanner in Table 1. Keep the record for future reference.
Table 1
Worksheet for the Configuration of the Scanner    
Serial number     Site    
Number of cylinders (1)     Number of turbochargers (1)    
Turbocharger's Display (1) (2)     Units (1)     "AUTOSCAN" (1)     Start-up Timer (1) (3)    
"TO" and "TI"     °C or °F     ON/OFF     minutes    
"TO" only     Filtering (1) (4)     Arming Temperature (1)        
"TI" only     value     degrees    
Setpoints and Temperatures (1)     "SETPOINTS ACTIVE W/ARM TEMP & TIMER" (5)     Output Switch 1
Configured (5)     Output Switch 2
Configured (5)    
"CYL DEV"     Yes or No     Yes or No     Yes or No    
"CYL HI 1"     Yes or No     Yes or No     Yes or No    
"CYL HI 2"     Yes or No     Yes or No     Yes or No    
"TO HI 1"     Yes or No     Yes or No     Yes or No    
"TO HI 2"     Yes or No     Yes or No     Yes or No    
"TI HI"     Yes or No     Yes or No     Yes or No    
Status of Output Switch 1 (5)     Status of Output Switch 2 (5)    
Normally open
Normally closed     Normally open
Normally closed    
Latching
Nonlatching     Latching
Nonlatching    
( 1 ) This parameter can be changed with the keypad.
( 2 ) TO = Turbocharger Outlet. TI = Turbocharger Inlet.
( 3 ) The timer can be set from 1 minute to 30 minutes.
( 4 ) The minimum filtering is 1. the maximum filtering is 255.
( 5 ) This parameter cannot be changed with the keypad.