SEAL-O-RING 6V6580 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     5P-8718     Rotor Support     1    
0S-1594 Bolt     4    
B     -     Guide Bolts (5/8 -18 NF)     2    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01039744
Install Tooling (A) on BrakeSaver housing (7) and the rotor.Note: Tooling (A) holds BrakeSaver housing (7) and the rotor assembly together during installation. This prevents damage to the rotor rings and seals.
Install a suitable lifting device to the top of BrakeSaver housing (7) .
Install Tooling (B) in the crankshaft. Ensure that dowel (8) is in alignment with the dowel hole in the rotor assembly. Position BrakeSaver housing (7) on the flywheel housing. The weight of the BrakeSaver housing is approximately 86 kg (190 lb).
Install the bolts that hold the BrakeSaver housing to the flywheel housing. Remove Tooling (A) and Tooling (B) .
Illustration 2 g01039695
Connect the hose assembly to fitting (5) .
Inspect the O-ring seals on manifold (3). If the O-ring seals are worn or damaged, use new parts for replacement. Install O-ring seals on manifold (3). Apply clean engine oil to the O-ring seals.
Install manifold (3) into the BrakeSaver housing and install short bolts (2) and longer bolts (4) that hold the manifold to the BrakeSaver housing.
Illustration 3 g00523078
Connect hose assembly (1) to the fitting in the BrakeSaver housing.End By: Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".