SEAL AS 7T5617 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Illustration 1 g00611965
Illustration 2 g00611967
Remove the bolts and cover (1) with the oil filler and the oil level gauge. Remove the O-ring seal from cover (1).
Remove gauge (2).
Remove tube (3) and the gasket.
Remove support (5).
Remove elbow (4) and the gaskets.Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctitie 536 -
B - Loctite LB 8632 Silicone Lubricant (1) -
- Loctite LB 8104 Silicone Lubricant (2) -
- Loctite LB 8801 Silicone Lubricant (3) -
- Loctite LB Superlube (4) -
(1) North America
(2) EAME
(3) Asia Pacific Division
(4) South America
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information. Refer to page 7 for torque values.
Inspect all parts and replace parts when replacement is required.
Illustration 3 g00611967
Illustration 4 g00611965
Install elbow (4) on cover (1) with new gaskets.
Install support (5).
Install tube (3) with a new gasket. Apply Tooling (A) to the threads.
Install gauge (2).
Install a new O-ring seal on cover (1). Use Tooling (B) to hold the O-ring seal in place.
Install cover (1) with the oil filler and the oil level gauge and the bolts.