SEAL-RING 7W0801 - Caterpillar

Connect hose assembly (31).
Illustration 35 g02524840
Connect steering frame link (23). Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Illustration 36 g02524861
Position steering neutralizer valves (28) and install bolts (27). Connect tube assembly (26).
Illustration 37 g02524857
Position bracket assembly (25) and install bolts (24).
Illustration 38 g02523601
Illustration 39 g02523618
The front pump drive shaft must be in phase. If the front pump drive shaft is not in phase, the machine could fail.
Secure front pump drive shaft (14) onto the forks of a suitable lift truck. The weight of the front pump drive shaft (14) is approximately 86 kg (190 lb). Position the front pump drive shaft (14) and install new bolts (16). Install new bolts (15). Tighten bolts (16) and bolts (15) to a torque of 300 30 N m (221 22 lb ft).
Illustration 40 g02523597
Connect bracket assembly (13).
Illustration 41 g02523541
Connect harness assembly (12).
Illustration 42 g02523536
Connect hose assembly (11), bracket (10), and hose assembly (9).
Illustration 43 g02523506
Connect hose assemblies (8).
Illustration 44 g02523456
Connect hose assemblies (7).
Illustration 45 g02523238
Remove Tooling (A) from steering cylinder (4).
Repeat Step 59 through Step 55 for the remaining steering cylinder.
Illustration 46 g02523185
Use a suitable lifting device to position the rod end of steering cylinder (4) onto the non-engine end frame.
Install pin assembly (6) and bolt (5).
Illustration 47 g02523149
Connect hose assembly (3).
Illustration 48 g02523072
Use a suitable lifting device to position the front slip joint (1). The weight of the front slip joint (1) is approximately 64 kg (140 lb). Install new bolts (2). Tighten bolts (2) to a torque of 530 70 N m (391 52 lb ft) End By:
Install the cab. Refer to Disassembly and Assembly, "Cab - Install".