SEAL KIT- 7X2695 - Caterpillar

7X2695 SEAL KIT- Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA7X2695
7X-2695
7X2695

Weight: 1 pounds 0 kg.

Buy SEAL KIT- 7X2695 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

7X2695 Var Cylinder Seal Kit Fits Cat Caterpillar 630B-637E-641B

$176.59

14 Dec 2019
1.02[0.45] Pounds
-: -

7X2695 Var Cylinder Seal Kit Fits Cat Caterpillar 630B-637E-641B
Warranty

Show more prices Caterpillar parts

For full view, you need register

Information:

Illustration 1 g00735296
Schematic of neutralizerThis diagnostic code is recorded if the high pressure switch is closed and the low pressure switch is open for more than 150 ms.Test Step 1. CHECK THE CIRCUIT FOR PROPER OPERATION
Turn the transmission neutralizer override switch to the ON position.
Disconnect the machine harness from the ECM.
At the harness connector, measure the resistance from frame ground to the inputs of the pressure switches (contact 4 and contact 14) while the brake pedal is NOT depressed.
At the harness connector, measure the resistance from frame ground to the inputs of the pressure switches (contact 4 and contact 14) while the brake pedal is depressed.Expected Result:The measured resistance should be greater than 5,000 ohms while the brake pedal is NOT depressed. The measured resistance should be less than 5 ohms while the brake pedal is depressed.Results:
OK - The measured resistance is greater than 5,000 ohms while the brake pedal is NOT depressed. The measured resistance is less than 5 ohms while the brake pedal is depressed. The switches are correct. The machine harness is correct. Proceed to test step 3.
NOT OK - The measured resistance is NOT greater than 5,000 ohms while the brake pedal is NOT depressed. The measured resistance is NOT less than 5 ohms while the brake pedal is depressed. The switches are NOT correct or the machine harness is NOT correct. Proceed to test step 2.Test Step 2. CHECK THE SWITCHES
At each switch, measure the resistance from frame ground to the inputs of the high pressure switch and the low pressure switch while the brake pedal is NOT depressed.
At each switch, measure the resistance from frame ground to the inputs of the high pressure switch and the low pressure switch while the brake pedal is depressed.Expected Result:The measured resistance at each switch should be greater than 5,000 ohms while the brake pedal is NOT depressed. The measured resistance at each switch should be less than 5 ohms while the brake pedal is depressed.Results:
OK - The measured resistance at each switch is greater than 5,000 ohms while the brake pedal is NOT depressed. The measured resistance at each switch is less than 5 ohms while the brake pedal is depressed. The switches are correct. The machine harness is not correct.Repair: Repair the machine harness or replace the machine harness. Stop.
NOT OK - The measured resistance at each switch is NOT greater than 5,000 ohms while the brake pedal is NOT depressed. The measured resistance at each switch is NOT less than 5 ohms while the brake pedal is depressed. The switches are NOT correct.Repair: Replace the switches that are faulty. Stop.Test Step 3. VERIFY THAT THE DIAGNOSTIC CODE IS PRESENT.
Turn the key start switch to the OFF position.
Inspect the connectors and inspect the contacts.
Connect the machine harness to the control module.
Install the relay.
Turn the key start switch to the ON position.
Enter the service mode.
Operate the machine.
Check the diagnostic indicator. Note the active diagnostic codes.Expected Result:The diagnostic code is active.Results:
YES - The diagnostic code is active.