SEAL KIT- 7X2798 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     6V-0006     Connector Pliers     1    
B     128-8827     Pin (1)     1    
C     1U-7523     Pin Pilot (1)     1    
( 1 ) Part of 9U-7305 Tool Group
Illustration 1 g00344799
Install the O-ring seal on governor (17). Carefully install governor (17) so that the fuel control linkage is not damaged. Install the washers and bolts (16) .
Illustration 2 g00344797
Illustration 3 g00344798
Install Tooling (B) into link pin (15) of the governor output shaft. When Tooling (B) is properly installed, equal lengths of the smaller end of Tooling (B) will extend from both ends of link pin (15) .
Install Tooling (C) onto the smaller end of Tooling (B) in order to help to align link pin (15) .
Use Tooling (A) to slide sleeve (14) away from the cylinder head and toward the governor. Install clip (13) .
Illustration 4 g00344796
Install cover (12) .
Put hose assembly (10) in position. Install clip (11), the washer and the bolt.
Illustration 5 g00344795
Connect tube assemblies (7), (8) and (9) .
Illustration 6 g00344794
Put bracket (5) and throttle cable (4) in position. Install bolts (6) and the nuts.
Connect throttle cable (4) .
Illustration 7 g00344792
Connect three wires (3) .
Install new tie-wrap (2) .
Connect hose assembly (1) .
Check the fuel setting adjustment.Reference: Refer to Systems Operation/Testing and Adjusting, SENR3583, "Basic Engine Components for 3114, 3116 and 3126 Engines" for the proper procedure.
Turn the battery disconnect switch to the OFF position and remove the key.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".