SEAL-LIP TYPE 7X4791 - Caterpillar

Assembly Procedure
Table 1
Tooling that is needed    A    B    
    Soldering iron (180 watt)            
    Vise or clamping support with vee blocks            
    Press            
8H-8581     Feeler Gauges     3        
1P-0510     Driver Set         1    
1P-0466     Plate         1    
1P-0529     Handle         1    
6L-5897     Bolt         1    
Illustration 1 g00871248
Install the roller bearing (1) with tooling (B) .Note: If necessary, apply grease to the bearing.
Illustration 2 g00871460
Install the ring (2) in the rear frame.
Illustration 3 g00871252
Install the insulators for terminal "B+" and terminal "D+".
Illustration 4 g00871347
Install the "R" terminal, if the "R" terminal was replaced.
Install the rectifier (3) in the rear frame.
Install the two screws. Solder the sleeve (4) over terminal "R".
Install the following components on terminals: "D+", "B+" and B-: terminal insulators, washers and nuts.
Illustration 5 g00871376
Position the stator frame (7) on the rear frame (5). Use the marks on the alternator that were made in the disassembly procedure for alignment.
Illustration 6 g00871382
Solder the leads for the stator winding (8) to the terminals for the rectifier (6) .
Illustration 7 g00871385
Install the bearing (9) in the rear frame.Note: The bearing is a loose fit.
Illustration 8 g00871389
Install the intermediate ring (10) .
Illustration 9 g00871402
Install the field winding (11). The leads for the winding must fit in the deep groove. Install the six screws on the reverse side of the frame.
Apply the epoxy putty 5P-3321 Adhesive over the lead and the groove.
Illustration 10 g00871407
Install the spacer ring (12) .