SEAL-LIP TYPE 8C0389 - Caterpillar

Machine ECM
The following is a list of Diagnostic Trouble Codes (DTCs) that are associated with the system voltage circuit of the machine.
Table 1
Machine ECM (MID 299)
DTC Code Description System Response
168-5 Electrical System Voltage : Current Below Normal Numerous machine system failures can be expected when this code is active. Possible Causes for an FMI 5 diagnostic code are:
A charging system component has failed.
The machine harness is open.
The Machine ECM has failed. A failure of the ECM is unlikely.
Illustration 1 g03588880
Machine ECM electrical system connections
Note: The diagram above is a simplified schematic of the System Voltage connections. The schematic is electrically correct. However, not all the possible harness connectors are shown. Refer to the latest revision of Electrical Schematic for your machine to view the complete schematic.Diagnostic Trouble Code Procedure
Note: Prior to beginning this procedure, inspect the harness connectors that are involved in this circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure, and in good condition. If a problem with a connection is found, correct the problem and verify that the diagnostic code is active before performing a troubleshooting procedure.
Table 2
Troubleshooting Test Steps Values Results
1. Identify Active FMI Code Associated With System Voltage Circuit Code present FMI 5 diagnostic code, proceed to Test Step 2.
Begin Process For FMI 5 Troubleshooting HERE
2. Check For An Open Circuit
A. Turn key start switch and disconnect switch OFF.
B. Disconnect the wire at alternator terminal labeled “W”.
C. Disconnect the same wire from the Switch Panel (see schematic above).
D. Connect one end of the wire to a know good ground.
E. Measure the resistance of the wire at the open end of the connector.
The resistance is 5 Ω or less. OK - The machine harness appears to work correctly. Either the alternator is not working correctly or the ECM may be recording the diagnostic code incorrectly.
Proceed to Test Step 3.
NOT OK - The resistance measurement is greater than 5K Ω. The wire in the harness between the alternator and the Switch Panel is open or damaged.
Repair: Repair or replace the wiring harness.
Note: A resistance that is greater than 5 Ω but less than 5K Ω would indicate a loose connection or a corroded connection in the circuit. A resistance measurement that is greater than 5K Ω would indicate an open in the circuit.
Proceed to Test Step 5.
3. Check The Charging System At High Idle
A. Turn key start switch and disconnect switch ON.
B.