SEAL KIT 8C5773 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench As     1    Start By:
Remove the engine side guard. Refer to Disassembly and Assembly, "Engine Side Guards - Remove and Install".Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Capacities - Refill" for the capacity of the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant (DEAC) - Change" or Operation and Maintenance Manual, "Cooling System Extended Life Coolant - Change" for the proper draining procedure.
Illustration 1 g01386746
Disconnect hose assembly (1). Remove cable strap (2). Disconnect harness assembly (3) .
Illustration 2 g01386756
Loosen bolt (4). Remove bolt (5).
Illustration 3 g01386778
Remove bolts (7). Remove bolts (6). Remove bonnet (8) .
Illustration 4 g01386781
Use Tooling (A) in order to remove filter assembly ( 9) .
Illustration 5 g01386784
Remove bolt (10) .
Illustration 6 g01386786
Remove bolts (11) .
Illustration 7 g01386791
Remove bolts (12). Remove bolt (13). Remove engine oil cooler (14) .