SEAL GP-DUO-CONE 8E6327 - Caterpillar

Illustration 1 g01203679
Hydraulic cab riser
When you exit the machine by using the alternate exit, maintain three points of contact by using the step and handrail on the cab riser.Rear Window with Hammer (If Equipped)
Illustration 2 g00748659
Alternate Exit - The rear window serves as an alternate exit.
Break Glass - A hammer is mounted at the rear of the cab. Perform the following procedure in order to exit through the rear window.
Strike the rear window with the hammer in order to break the glass.
Climb through the opening of the rear window in order to exit the cab. Rear Window with Ring Seal (If Equipped)
Illustration 3 g00681020
(1) Ring
(2) O-ring seal To remove the rear window, pull ring (1) and push out the glass.Completely remove O-ring seal (2) from the seal that supports the glazing support seal. This will provide enough clearance so that the seal can hinge and the glazing can pass outward.Rear Window with Lever (If Equipped)
The rear window can be removed from the inside of the cab or from the outside of the cab.Note: When lock pin (1) is in the locked position (B), the rear window cannot be removed. When you operate the machine, place lock pin (1) in unlocked position (A).Removing Rear Window from the Inside
Illustration 4 g01005072
(1) Lock pin
(2) Lever
(A) Unlocked position
(B) Locked position
Place lock pin (1) in unlocked position (A).
Grip the lever (2). Fully turn the lever in the direction of the arrow and push the rear window outward. Removing Rear Window from the Outside
Illustration 5 g01005071
Make sure that lock pin (1) is in the unlocked position (A).
Grip lever (3). Fully turn the lever in the direction of the arrow and pull backward in order to remove the window.