SEAL AS 8T1794 - Caterpillar

Customer specified parameters that will enhance the fuel efficiency and the operator's convenience can be programmed into the Electronic Control Module (ECM). Some parameters may affect engine operation. This may lead to complaints from the operator about power or about performance. Certain engine parameters may be programmed by the customer by using Caterpillar electronic service tools in order to influence the operation of the engine:The customer specified parameters can be changed as often as needed. Password protection is provided so that the customer can change the parameters. The customer can authorize someone else to change the parameters. Ensure that a record of the parameters is kept in the Operation and Maintenance Manual, "Customer Specified Parameters" (Product Information Section). For detailed instructions on programming the engine for optimum performance and for optimum fuel economy, consult your Caterpillar dealer.To record programmed specifications, use the following blanks.Customer Passwords
First Password ____________________
Second Password ____________________Power Rating (hp at rpm) ____________________Rating Selection (A-E) ____________________Vehicle ID ____________________Vehicle Speed Parameters
Vehicle Speed Calibration ____________________ pulses per km (pulses per mile)
Vehicle Speed Limit ____________________ km/h (mph)
Vehicle Speed Limit Protection ____________________
Tachometer Calibration ____________________ pulses per revolution
Soft Vehicle Speed Limit ____________________Cruise Control Parameters
Low Cruise Control Speed Set Limit ____________________ km/h (mph)
High Cruise Control Speed Set Limit ____________________ km/h (mph)
Engine Brake ____________________
Cruise/Idle/PTO Switch Configuration ____________________
Soft Cruise Control ____________________Idle Parameters
Idle Vehicle Speed Limit ____________________ km/h (mph)
Idle RPM Limit ____________________
PTO Engine Speed Ramp Rate ____________________ rpm/sec
PTO Bump RPM ____________________PTO Parameters
PTO Configuration ____________________
PTO Top Engine Limit ____________________
PTO Engine RPM Set Speed ____________________
PTO Engine RPM Set Speed A ____________________
PTO Engine RPM Set Speed B ____________________
PTO to Set Speed ____________________
PTO Cab Throttle RPM Limit ____________________
PTO Vehicle Speed Limit ____________________
Torque Limit ____________________ N m (lb ft)
PTO Shutdown Time ____________________
PTO Shutdown Timer Maximum RPM ____________________
PTO Activation of Cooling Fan (If Equipped) ____________________Engine/Gear Speed Limit Parameters
Lower Gears Engine RPM Limit ____________________
Lower Gears Turn Off Speed ____________________ km/h (mph)
Intermediate Gears Engine RPM Limit ____________________
Intermediate Gears Turn Off Speed ____________________ km/h (mph)
Gear Down Protection RPM Limit ____________________
Gear Down Protection Turn On Speed ____________________ km/h (mph)
Low Idle Engine RPM ____________________
Transmission Style (If Equipped) ____________________Timer Parameters
Idle Shutdown Time ____________________
Idle Shutdown Timer Maximum RPM ____________________
Idle Shutdown Override Allowance ____________________
Minimum Shutdown Idle Shutdown Outside Temperature ____________________
Maximum Shutdown Idle Shutdown Outside Temperature ____________________
A/C Pressure Switch Fan On - Time (If Equipped) ____________________
Fan with Engine Brake On - Full (If Equipped) ____________________
Engine Compression Brake Delay ____________________Smart Idle Parameters
Battery Monitor and Engine Speed Control Voltage ____________________Engine Monitoring Parameters
Engine Monitoring Mode ____________________
Coolant Level Sensor (If Equipped) ____________________Maintenance Indicator Parameters
Maintenance Indicator Mode ____________________
PM 1 Interval (Manual) ____________________
Engine Oil Capacity (Automatic) ____________________Trip Parameters
Dash - PM Level 1 Reset ____________________
Dash - Fleet Trip Reset ____________________
Dash - State Selection ____________________
Theft Deterrent System Control ____________________
Theft Deterrent Password ____________________Vehicle Activity Report
Minimum Idle Time ____________________