SEAL -HEAD 8T8367 - Caterpillar

Disassembly Procedure
Remove the seat from the machine. Separate the seat from the air suspension.
Illustration 1 g00275844
Typical Example
Remove boot (1).
Illustration 2 g00275845
Typical Example
Loosen the setscrew on knob (2) and remove the knob. Remove nut (3) and the lock washer.
Remove locknut (4) and the lock washer. Remove the upper shaft assembly.
Illustration 3 g00275846
Tilt upper housing (6) forward. Slide the upper housing off scissor assembly (7).
Illustration 4 g00275848
Remove screw (7) from the air spring, which is not shown.
Illustration 5 g00275849
Disconnect two tether belts (10). Remove two bearings (9) and two rollers (9).
Illustration 6 g00275850
Disconnect tube (12) from fitting (11).
Illustration 7 g00275851
Remove locknut (13) and the lock washer. Remove the lower shaft assembly.
Illustration 8 g00275854
Remove two tether belts (10). Lift up scissor assembly (5) and slide the scissor assembly out of lower housing (14).
Illustration 9 g00275855
Typical Example
Remove cap (15) and shaft (16) from damper (18). Remove locknut (19), the pin, bearings (17) and (20), and damper (18).
Illustration 10 g00275856
Remove fitting (11) from lower housing (14).
Illustration 11 g00275857
Remove two bearings (21) and two rollers (24) from scissor assembly (5). Disconnect tubes (22) and (12) from valve assembly (23).
Illustration 12 g00275858
Illustration 13 g00275860
Remove two bumpers (25). Remove bolt (27) from air spring (28).
Disconnect tube (22) from fitting (26). Remove air spring (28) from scissor assembly (5).
Cut tie-wraps (29) that are holding tubes (22) and (12) to scissor assembly (5).
Illustration 14 g00275862
Typical Example
Remove two bolts (32) and the washers. Remove locknut (30) and the washer. Remove bolt (33). Remove slider track (31) from upper housing (6).