SEAL 9G9079 - Caterpillar

(1) 8M9141 Spring for governor high idle: Load under force of ... 6.30 lb.(2,85 kg) Then compress an additional ... .370 in.(9,398 mm)Total test force reading ... 10.75 .20 lb.(4,88 0,09 kg)Free length after test ... 2.340 .030 in.(59,44 0,76 mm)Outside diameter ... 1.371 .015 in.(34,82 0,38 mm)(2) Torque for locknut ... 11 1 lb. ft.(1,52 0,14 mkg) On natural gas engines, adjustment of stop screw should limit governor stop collar travel to .605 in. (15,37 mm) from fuel off position.(3) 8M6303 Spring for inner thrust: Length under test force ... .18 in.(4,57 mm)Test force ... 9.5-10.5 lbs.(4,3-4,7 kg)Free length after test ... .344 in.(8,74 mm)Outside diameter ... .478-.482 in.(12,14-12,24 mm)(4) Torque for 3/8 in. nut ... 36-48 lb. in.(41,5-55,3 cm.kg) Torque for 1/4 in. bolt ... 6-12 lb. ft.(0,83-1,66 mkg)(5) Diameter of pump shaft bearing upper journal ... .6265-.6271 in.(15,913-15,928 mm) Bore in the cover ... .6313-.6323 in.(16,035-16,060 mm)(6) Distance bearing extends ... .465-.475 in.(11,81-12,06 mm)(7) Clearance between pump gear and cover ... .0009-.0021 in.(0,023-0,053 mm)(8) Diameter of new idler gear bearing ... .8107-.8113 in.(20,592-20,608 mm) Bore in new pump idler gear ... .8125-.8135 in.(20,638-20,663 mm)(9) Diameter of new drive shaft lower journals ... .6855-.6865 in.(17,411-17,437 mm) Bore in the housing ... .6875-.6885 in.(17,462-17,488 mm)(10) Shaft end play ... .02-.06 in.(0,5-1,5 mm)