SEAL-QUAD RING 9J8116 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0510 Driver Group 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02352498
Illustration 2 g01146257
Illustration 3 g02352555
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Use Tooling (A) to install bearings (14) in body (4) until the bearings are 0.30 0.25 mm (0.012 0.010 inch) from the inside edge of the bearing bores. Install bearings (14) so the junctions in the bearings are 30 15 degrees from the center line of the bearing bores, and toward the outlet passage. The outlet passage has a cavity between the bearing bores.
Install plunger (9), plunger ring (10), and spring (11).
Install retainer (12) and bolts (13).
Install shaft assemblies (15) into body (4).
Use Tooling (A) to install bearings (16) in cover (17) until the bearings are even with the outside surface of cover. Install bearings (16) so the junctions in the bearings are 30 15 degrees from the center line of the bearing bores and toward the outlet passage in the oil pump.
Install cover (17) on body (4). Install bolts (18).