SEAL-O-RING 9X7566 - Caterpillar

Automatic Starting
When the engine is in the AUTOMATIC mode, the engine can start at any moment. To avoid personal injury, always remain clear of the the engine when the engine is in the AUTOMATIC mode.
For automatic starting, the engine control switch must be in the REMOTE position. The engine will automatically start when the remote start/stop initiate contact closes.Manual Starting
For initial start-up of a new or rebuilt engine, and for start-up of an engine that has been serviced, make provision to shut the engine off should an overspeed occur. This may be accomplished by shutting off the air and/or fuel supply to the engine.
Do not start the engine if a "DO NOT OPERATE" warning tag or a similar warning tag is attached to any of the controls.Ensure that no one will be endangered before the engine is started and when the engine is started.Perform all of the procedures that are described in this Operation and Maintenance Manual, "Before Starting Engine" topic.
Do not engage the starting motor when flywheel is turning. Do not start the engine under load.If the engine fails to start within 30 seconds, release the starter switch or button and wait two minutes to allow the starting motor to cool before attempting to start the engine again.
Note: If the optional prelube is used, the prelube pump will operate before cranking begins. The ECM will allow the engine to be operated at rated rpm when the oil pressure sensors indicate that the oil pressure is sufficient.Starting the Engine with the Cat Marine Generator Control Panel (MGCP) (If Equipped)
Illustration 1 g03878119
Cat Marine Generator Control Panel (MGCP) II
(1) Start switch
(2) Throttle switch
(3) Engine Control Switch (ECS) "OFF/Local/Remote"
Illustration 2 g03878120
Cat Marine Generator Control Panel (MGCP) IIIb
(1) Start switch
(2) Throttle switch
(3) Engine Control Switch (ECS) "OFF/Local/Remote"
Illustration 3 g03878000
(5) Crank Override switch
(6) Shutdown Override switch
(7) Crank Inhibit switch Note: Refer to this Operation and Maintenance Manual, "Control Panel" for additional information on switch positions and definitions.When the ECS (3) is in LOCAL mode, the engine cannot be started from the remote control unit.
Position the ECS to the LOCAL position.
Push the Start button (3) to start the engine. Note: If the Start button does not start the engine, start the engine with the Crank Override switch (5) on the inside of the control box.