SEAT GP-SUSPENSION 1075834 - Caterpillar

Secondary Desired Speed Input Configuration
This parameter defines the type of input signal that is delivered to the ECM for the secondary speed control.Note: This parameter is not normally used when the application is equipped with an EMCP 3.
Table 32
Options Default
CAN Input
Not Installed
PWM Not Installed System Settings
Fuel Correction Factor
This feature is not available for this application.Governor (Proportional)Gain Percentage
This parameter is used in determining the rate of response to an engine load.
Table 33
Minimum Default Maximum
1 100 1000 Governor (Integral)) Stability Percentage
This parameter is used by the ECM to offset the steady state speed error when the steady state speed error is less than 20 rpm.
Table 34
Minimum Default Maximum
1 100 1000 Governor Transient Loop Gain Percentage
This parameter is used by the ECM to offset the steady state speed error when the steady state speed error is greater than 20 rpm.
Table 35
Minimum Default Maximum
1 100 1000 Desired Engine Coolant Temperature Configuration
This parameter is used to program setting for coolant temperature that will be used by the TCM for the engine.
Table 36
Minimum Default Maximum
40 85 102 Exhaust Temperature Module Installation Status
This parameter defines the installation status of the exhaust temperature module.
Table 37
Options Default
Installed
Not Installed Not Installed Full Load Setting (FLS)
FLS represents the adjustment to the fuel system that was made at the factory in order to fine-tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter.
Table 38
Minimum Default Maximum
−128 0 127 Full Torque Setting (FTS)
FTS is like FLS. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter.
Table 39
Minimum Default Maximum
−128 0 127 Security Access Parameters
Total Tattletale
The total tattletale counts the number of changes that are made to the system parameters.CAN Communication Protocol Write Security
The CAN Communication Protocol Write Security parameter control the security required for writing information through the CAN bus.
Table 40
Value Default
Seed and Key
No Security Seed and Key CAN Communication Protocol Read Security
The CAN Communication Protocol Read Security parameter control the security required for reading information from the CAN bus.
Table 41
Value Default
Seed and Key
No Security Seed and Key