SEAT BELT GP 2306367 - Caterpillar

Illustration 2 g03834416
Right-hand joystick with thumb wheel (B-Series, C-Series, and D-Series SSL / MTL / CTL)
Table 1
BRX118, BRX318, and BRX418 Controls
(B-Series, C-Series, and D-Series SSL / MTL / CTL)
Function SSL / MTL / CTL Controls
Brush Cutter ACTIVATE 2 or A2
Brush Cutter DEACTIVATE 1 or A1
After the brush cutter has been turned OFF, the brush cutter will continue to rotate for some time, due to inertia. Allow the brush cutter to come to a complete stop before proceeding.
Removal Of Obstructions From Work Tool
Note: When an obstruction prevents the work tool from operating, use the following procedure.If the work tool becomes obstructed, first attempt to remove the obstruction by operating the work tool in the REVERSE direction. Once the obstruction has been removed, operate the work tool in the FORWARD direction.
Do not use an auxiliary override with this work tool. The work tool can be fully powered even if the arm bar is raised and the operator has exited the cab.Severe injury or death could occur.Do not exit the cab until the work tool and the host machine have been shutdown and the parking brake is engaged.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
If the obstruction is not removable by operating the work tool in the REVERSE direction, refer to the following procedures for removing obstructions:Note: It is necessary to release the hydraulic system pressure of the host machine before you connect or before you disconnect the hydraulic lines of the work tool to the machine. Refer to the Operation and Maintenance Manual of the host machine for the proper procedure in order to release the hydraulic system pressure of the host machine.Procedure To Remove Obstructions For B-Series Machines
Note: It is necessary to release the hydraulic system pressure of the host machine before you connect or before you disconnect the hydraulic lines of the work tool to the machine. Refer to the Operation and Maintenance Manual of the host machine for details.
Fully release the hydraulic system pressure from the work tool. Release the hydraulic system pressure with the following procedures:
Start the engine and run the engine for at least 15 seconds in order to recharge the accumulator.
Turn the engine start switch to the OFF position.
Do not raise the armrest.
Immediately, turn the engine start switch to the ON position. Disengage the parking brake.
Move both of the joystick controls through all of the operating positions in order to release the hydraulic pressure in the work tool system and the hydrostatic system.
Press each side of the auxiliary hydraulic control switch