SEAT GP-SUSPENSION 2324772 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2
B 9U-6238 Guide Bolt 2
C - LOCTITE 242 -
D - LOCTITE 5900 Flange Sealant - Start By:
Remove the air cleaner housing.
Remove the auxiliary water pump.
Remove the center exhaust manifold.
Remove the flywheel.
Remove the crankshaft rear seal and the wear sleeve.
Remove the electric starting motor.
Illustration 1 g02699662
Remove bolts (1) from the oil pan.
Illustration 2 g02699663
Typical Example
Loosen bolts (2) and allow the pan to drop about 6.4 mm (0.25 inch) for some clearance.
Illustration 3 g02699664
Illustration 4 g02699668
Typical Example
Remove cover (3).
Fasten Tooling (A) and a suitable lifting device to flywheel housing (6).
Remove two bolts (5) and install Tooling (C). Remove bolts (4) and the rest of bolts (5).
Remove flywheel housing (6). The weight of flywheel housing (6) is approximately 86 kg (190 lb).
Illustration 5 g02699669
Remove and discard gasket (7). Installation Procedure
Install flywheel housing (6) in the reverse order of removal.
Ensure that gasket (7) and the mating surfaces of the flywheel housing and engine block are cleaned of all contaminates. Trim gasket (7) flush with the engine block after installation.
Illustration 6 g00270422
Apply Tooling (C) to bolts (4).
In a numerical sequence, tighten bolts 1 through 8 to a torque of 135 14 N m (100 10 lb ft).
In a numerical sequence, tighten bolts 9 through 20 to a torque of 55 7 N m (40 5 lb ft).
In a numerical sequence, again tighten bolts 1 through 8 to a torque of 135 14 N m (100 10 lb ft).
In a numerical sequence, again tighten bolts 9 through 20 to a torque of 55 7 N m (40 5 lb ft).
Before installing bolts (2) and (1), apply Tooling (D) to the corners of the oil pan. Refer to the Disassemble and Assemble , "Oil Pan - Remove and Install" for further instructions.