SEAT G 2C7733 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the machine that is being serviced.
Remove the tire and rim. Refer to Disassembly and Assembly, "Tire and Rim - Remove". Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00611234
Remove bolts (1). Remove cover (2).
Illustration 2 g00611240
Disconnect hose assemblies (3). Note: Hose assembly (4) is not removed at this time.
Illustration 3 g00611355
Support the travel motor with a suitable lifting device. Remove bolts (5). The weight of the travel motor is approximately 277 kg (610 lb).
Illustration 4 g00611395
Move the travel motor away from the pendulum arm to a distance of approximately 7.50 cm (3.000 inch). Disconnect hose assembly (4).
Illustration 5 g00953969
Disconnect hose assembly (6) from the front of the travel motor. Remove travel motor (7) from the machine.