SEAT-VALVE 3229664 - Caterpillar

Setting The Truck Counter
To keep track of the number of trucks that are loaded during a shift, the operator should zero the truck counter to zero at the beginning of the shift. Use the following procedure to zero the truck counter. Press the "F1" key in order to bring up the payload menu. Then press the "1" key for the "1: ENTER MISC INFO" option.
Table 1
0: ENTER TRUCK ID        
1: ENTER MISC INFO        Press the "4" key for the "4:SET TRK COUNTER" option.
Table 2
3: ENTER TRGT TRK WT        
4:SET TRK COUNTER        The "SET TRK COUNTER" option will be displayed with the current "truck count" on the second line of the message center: Note: This is the total "truck count" since the last reset.
Table 3
SET TRK COUNTER        
231        Press "0" and then press the "OK" key in order to reset the counter:
Table 4
SET TRK COUNTER        
0        Viewing the Truck Counter
The two methods that are available to view the truck counter are given below: Method 1Access the "4: SET TRK COUNTER" option that is described above. This will allow the current value of the truck counter to be viewed without changing the count. Press the "OK" key in order to exit. Do Not press any other keys while these values are viewed.Method 2The operator changes the "payload display mode" to the "3: COUNTER WT DISP". Refer to the Systems Operation, "Display Mode Selecting" section of this manual for more information.