SEAT BELT GP 3535342 - Caterpillar

START BY:a) remove wheels 1. Install two blocks (1) between the brake shoes and axle housing as shown so the brake camshaft can be removed. 2. Use tool (A) to move snap ring (2) to the right, away from guard (3). Move the washer behind snap ring (2) away from the guard. 3. Remove the cotter pin and pin (5) that hold the end of slack adjuster (4) in position in the yoke on the brake actuator. 4. Pull the brake camshaft out of the frame far enough that the slack adjuster can be removed from the end of the brake camshaft.5. Remove brake camshaft (6), washers (7) and (8) and snap ring (2). 6. Remove two lip type seals (9) from the rear support for the brake camshaft. Use tool (B) to remove the bearing from the rear support. 7. Remove two lip type seals (10) from the axle housing. Use tooling (C) to remove bearing (11).Install Brake Camshafts And Slack Adjusters
1. Use tooling (A) to install bearing (1) in the axle housing.2. Use tooling (A) to install the two lip type seals in the axle housing. Install the seals with the lips in as shown. Put 1P808 General Purpose Type Grease on the lip of each seal and on the bearing. 3. Use tooling (A) to install the bearing in rear support (2). Install the bearing so it is in the middle of the rear support.4. Use tooling (A) to install the two lip type seals in the rear support. Install the seals with the lips out as shown. Put 1P808 General Purpose Type Grease on the lip of each seal and on the bearing. 5. Put washer (4) in position on brake camshaft (3). Install the brake camshaft through the axle housing. Install washer (5) on the brake camshaft. Use tool (B) to install snap ring (6).6. Install the brake camshaft part way into the scraper frame. 7. Install slack adjuster (7) on the end of the brake camshaft. Make sure bolt (9) is down as shown. Install the brake camshaft the rest of the way into the machine.8. Put the end of the slack adjuster in position in the end of the brake actuator. Install pin (8) and the cotter pin. 9. Put washer (5) in position against the axle housing. Use tool (B) to install snap ring (6) in the groove in the brake camshaft. 10. Remove two blocks (10).END BY:a) install wheels