SEAT BELT GP 3573820 - Caterpillar

1. Remove the bolts and retainers (1) from front roller frame (2).2. Remove cylinder (3) from the front roller frame. 3. Remove bolts (4) and plate assembly (5). 4. Remove O-ring seal (7), valve (6) and valve (8) from cylinder (3). 5. Remove plug (9) from cylinder (3). Remove the O-ring seal from the plug. 6. Remove piston (11).7. Remove seal assembly (10) from cylinder (3). The following steps are for installation of the track adjusters.8. Install seal assembly (10) in cylinder (3). Install the seal assembly with the lip toward the inside of the cylinder as shown.9. Align the flat surface (X) on piston (11) with the flat surface inside the cylinder, and install piston (11) in cylinder (3). Install the piston until surface (X) is past the lip of seal assembly (10).10. Install the O-ring seal on plug (9). Install the plug in the cylinder.11. Install valves (6) and (8). Put O-ring seal (7) in position on cylinder (3).12. Put plate assembly (5) in position on the cylinder, and install two bolts (4).13. Use the following procedure to evacuate all of the air from the track adjuster:a. Fill the track adjuster with SAE 30W oil.b. Position the track adjuster on the floor with piston (11) down.c. Open valves (6) and (8). Push cylinder (3) down onto the piston until all of the air is removed from the track adjuster.d. Close valves (6) and (8).14. Install cylinder (3) in the front track roller frame as shown. Put retainers (1) in position, and install the bolts that hold them.End By:a. install front track roller frames