3C8527 SEAT GP (B)- Caterpillar parts
Rating:
Alternative (cross code) number:
CA3C8527
3C-8527
3C8527
CA3C8527
3C-8527
3C8527
Weight: 10 pounds 4 kg.
For full view, you need register
Information:
Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01195044
Disconnect harness assembly (2) .
Remove injection actuation pressure sensor (1) .
Remove the O-ring seal from injection actuation pressure sensor (1) .Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01195044
Install a new O-ring seal on injection actuation pressure sensor (1) .
Install injection actuation pressure sensor (1) and tighten to a torque of 10 2 N m (89 18 lb in).
Connect harness assembly (2) .
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01195044
Disconnect harness assembly (2) .
Remove injection actuation pressure sensor (1) .
Remove the O-ring seal from injection actuation pressure sensor (1) .Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01195044
Install a new O-ring seal on injection actuation pressure sensor (1) .
Install injection actuation pressure sensor (1) and tighten to a torque of 10 2 N m (89 18 lb in).
Connect harness assembly (2) .