SEAT GP-SUSPENSION 4211281 - Caterpillar

For the trigger condition severity levels listed in the table above from "Condition Exists, Red On, other Not Used" to "Condition Does Not Exists, Green On, other Not used, Horn On" the following suspect parameter number options can be used:
Table 17
Suspect Parameter Number Text Value
Digital Input # 1 Custom Event 701
Digital Input # 2 Custom Event 702
Digital Input # 3 Custom Event 703
Digital Input # 4 Custom Event 704
Digital Input # 5 Custom Event 705
Digital Input # 6 Custom Event 706
Digital Input # 7 Custom Event 707
Digital Input # 8 Custom Event 708
Isolated Digital Input #1 Custom Event 3920
Isolated Digital Input #2 Custom Event 3921
Isolated Digital Input #3 Custom Event 3922
Isolated Digital Input #4 Custom Event 3923
Emergency Stop Shutdown 970
Emergency Shutdown Override Mode Active 1237
Fuel Tank Leak 1239
Engine Failure to Start 1664
Service Interval Warning 2648
Generator Unavailable to Start/Run 3677
EPS Supplying Load 3829
Air Damper Closed 4000
ATS in Normal Position 4001
ATS in Emergency Position 4002
Battery Charger Failure 4003
Generator Breaker Closed 4004
Utility Breaker Closed 4005
Engine in Cooldown 4006
Generator Control Not in Automatic Warning 4007
Generator Breaker Failure to Open 4009
Generator Breaker Failure to Close 4011
Generator Breaker Open 4013
Loss of Utility 4017
Generator Breaker Locked Out 4018
Utility Breaker Locked Out 4019
Bus Phase Sequence Incorrect 4024
Generator Phase Sequence Incorrect 4025
Earth Fault 4028
Earth Leakage 4029 If the "Trigger Condition Severity Level" is programmed for "Diagnostic", then the failure mode identifier for any pair of LEDs can be configured as any of the following:
Table 18
Data Erratic, Intermittent, or Incorrect Abnormal Rate of Change
Voltage Above Normal, or Shorted to High Source Root Cause Not Known
Voltage Below Normal, or Shorted to Low Source Bad Intelligent Device or Component
Current Below Normal or Open Circuit Out Of Calibration
Current Above Normal or Grounded Circuit Special Instructions
Mechanical System Not Responding or Out of adjustment Received Network Data In Error
Abnormal Frequency or Pulse Width or Period Data Drifted High
Abnormal Update Rate Data Drifted Low Adding an Additional Remote Annunciator
An additional remote annunciator may be added if desired. In order to operate properly, the annunciator must be located within 1219 m (4000 ft) of the EMCP 4. Refer to Illustration 28 or Illustration 29.
Illustration 28 g02281501
Illustration 29 g02281673