SEAT GP-SUSPENSION 4438262 - Caterpillar

Remove the two hose assemblies (18) .
Remove pressure control valve group (15) and elbow (17) from the oil pump.
Remove elbow (17) from pressure control valve group (15) .
Remove elbow (16) from elbow (17) .
Install the 241-6158 Plug and one 228-7102 O-Ring Seal into elbow (9) .
Using a suitable lifting device, remove pressure control valve group (15). The pressure control valve group weighs approximately 30 kg (66 lb).
Illustration 11 g03526299
(19) 380-4432 Pressure Control Valve Gp (20) Square manifold with the 327-0817 Check Valve Gp (21) Cap assembly
Illustration 12 g03527868
(17) 353-5985 Elbow (19) 380-4432 Pressure Control Valve Gp (22) 112-8186 O-Ring Seal (23) Oil tube assembly (24) 269-7885 O-Ring Seal (25) Side cover (26) 272-0759 Seal
Install two O-rings (24) onto oil tube assembly (23) .Note: Lubricate the O-rings with engine oil.
Install the oil tube assembly (23) into pressure control valve group (19) .
Using a suitable lifting device, install pressure control valve group (19) and oil tube assembly (23) into side cover (25). The pressure control valve group and oil tube assembly weigh approximately 30 kg (66 lb).
Attach elbow (17) to pressure control valve group (19) with one O-ring (22) and the original hardware.
Illustration 13 g03526302
The 353-5985 Elbow is hidden to show O-rings. (27) Connector (28) 228-7089 O-Ring Seal (29) 228-7106 O-Ring Seal (30) 418-1262 Hose As (31) 3E-6751 O-Ring Seal
Attach the 353-5985 Elbow to the oil pump with one O-ring (31) and the original hardware.
Remove the original connector (27) from the engine.
Remove the two original O-rings from connector (27) .
Install the original connector (27) and one O-ring (28) into the engine.
Attach hose assembly (30) and one O-ring (29) to connector (27) .
Remove the cap assembly from the 327-0817 Check Valve Gp .
Attach hose assembly (30) to the 327-0817 Check Valve Gp .Note: Make sure that the O-ring is in the 327-0817 Check Valve Gp .
Illustration 14 g03529756
(32) 109-7411 O-Ring Seal (33) 6V-3835 O-Ring Seal Note: Use O-rings (32) and (33) if the oil pump is removed from the engine.
Illustration 15 g03527864
(34) 6V-1196 O-Ring Seal (35) 346-7703 O-Ring Seal
Install one O-ring (35) onto each end of the oil tube assemblies.
Install one O-ring (34) into each flange.
Illustration 16 g03527862
(2) Intake manifold (3) Coolant pipe (11) 258-9926 Gasket (14) 095-1687 O-Ring Seal
Attach intake manifold (2) to the engine with two gaskets (11), two O-rings (12), and the original hardware.
Install water pipe (3) with the original hardware.
Illustration 17 g03526256
(1) Wiring harness
Attach wiring harness (1) to the engine with the original hardware.