SEAT GP-SUSPENSION 4853442 - Caterpillar

Table 1
OPERATION    
Warning Level     Action Alarm     Action Indicator     Advisor Display Pop-Up Message     System Warning Indicator    
Level 1     OFF     OFF     OFF     ON    
Level 2     OFF     Flashing ON and OFF     ON     ON    
Level 3     Pulsing ON and OFF     Flashing ON and OFF     ON     ON    Note: "Level 2" warnings will use the Advisor Display Pop-Up Message for a certain fault. A "Level 2" warning will determine if the Advisor Display Pop-Up Message is used.The following conditions will activate the indicator for an operator error:
The measurement of height of the material during the paving operation changes from the "paddle sensor" to the "sonic sensor" or vice versa.
The left speed sensors and right speed sensors are incorrectly installed.
If any of the switches for the feeder system are in the manual position at engine start-up, an error will occur.
The machine is operating in an open loop mode.
The machine is in a runaway condition.
A gear change with the propel lever out of the neutral position
An engine fuel shutdown has been commanded by the machine controller.
A change of station is commanded with the propel lever out of the neutral position.
If the signal from the sonic sensor is greater than the 94% duty cycle, an error will occur.
If the propel lever is out of neutral and the parking brake is set, an error will occur.
If the hold switch for the screed lift is in the down position when the key switch is turned ON, an error will occur. (The operator must reset the hold switch of the screed lift before the engine will start.)
Illustration 1 g01114340
Typical AdvisorDisplay Pop-Up MessageThe action that is taken by the machine operator for the different warning levels is listed below:Level 1 - This warning level will cause the involved system alert indicator to illuminate. A "Level 1" warning will indicate that the operator should be aware of a condition of one or more of the machine systems.Level 2 - This warning level will indicate that the operation of the machine should be changed or that maintenance should be performed to the machine. Possible damage to components on the machine may occur without a change in operation or maintenance.Level 3 - This warning level will indicate that the machine needs to have an immediate, safe emergency engine shutdown. Possible injury to the operator or severe damage to components may occur.If an action alarm, alert indicator, or a warning occurs, a popup message will override any screen that was displayed on the Advisor display module.When a warning message is displayed on the Advisor display module, press the "OK" button in order to acknowledge the warning. This will remove the warning message from the display for a predetermined duration of time. Refer to Table 2.
Table 2
Warning Acknowledgment Durations    
Warning Level    Duration    
Level 1     1 hour    
Level 2     1 hour    
Level 3     1 hour