SEAT GP 5075490 - Caterpillar

Security System Immobilizer Installation Status
This feature enables the ECM to provide the functionality for the installation of a Machine Security System (MSS). Engine Retarder Enable Command (Option)
This parameter is enabled in order to define the installation status of compression brakes for the engine.Engine Warmup Elevated Idle Feature Enable Status
This feature allows a strategy for elevated idle to be enabled during cold engine operation.Parameter Table
Table 1
System Configuration Parameters    
Parameter    Available Range or Options    Default    Required Password    
Configuration Group 1    
Equipment ID     17 alphanumeric characters     Blank     None    
ECM Identification Parameters    
Engine Serial Number     0XX00000 or XXX00000     Blank     Factory    
ECM Serial Number     Hardware Dependent     Blank     Read Only (1)    
ECM Part Number     Hardware Dependent     Blank     Read Only (1)    
Software Group Part Number     Software Dependent     Read Only (1)    
Software Group Release Date     Software Dependent     Read Only (1)    
Software Group Description     Software Dependent     Read Only (1)    
System Parameters    
FLS     Programmed at the Factory     Factory    
FTS     Programmed at the Factory     Factory    
Rated Power     Software Dependent     Read Only (1)    
Rated Peak Torque     Software Dependent     Read Only (1)    
Top Engine Speed Range     Software Dependent     Read Only (1)    
Test Spec     Software Dependent     Read Only (1)    
Total Tattletale     0 to 65535     0     Read Only (1)    
Engine Configuration Parameters    
Low System Battery Voltage Elevated Idle     Enabled
Disabled     Enabled     None    
Ether Solenoid Configuration     Not Installed
Continuous Flow Solenoid     Continuous Flow Solenoid     Customer    
Engine Cooling Fan Map     Standard
High Ambient     Standard     Factory    
Security System Immobilizer Installation Status     Installed
or
Not Installed     Not Installed     Factory    
Engine Retarder Enable Command (Option)     Enabled
Disabled     Disabled     None    
Engine Warmup Elevated Idle Feature Enable Status     Enabled
Disabled     Disabled     None    
( 1 ) This parameter can be viewed only. No changes are allowed.Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters    
Equipment ID    
   
Engine Serial Number    
   
ECM Serial Number    
   
ECM Part Number    
   
Software Group Part Number    
   
Software Group Release Date    
   
Total Tattletale    
   
FLS    
   
FTS    
   
Low System Battery Voltage Elevated Idle    
   
Ether Solenoid Configuration    
   
Engine Fan Reversing Feature    
   
Engine Cooling Fan Map    
   
Security System Immobilizer Installation Status    
   
Engine Retarder Enable Command    
   
Engine Warmup Elevated Idle Feature Enable Status    
   
Table 3
Information From Engine Information Plate    
Engine Serial Number    
   
FLS    
   
FTS    
   Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Use of incorrect parameters could cause damage to the engine. Use of