SEAT 5I5175 - Caterpillar

13. Install two discs (26) and one plate (25) on the end plate starting with a disc. These discs and this plate are for the No.3 clutch. 14. Install springs (24). Install the dowels in housing (22). Install the inner and the outer ring seals on piston (23). Install piston (23) in housing (22). Install housing (22). Make sure springs (24) are in their correct locations in the end plate and piston (23). 15. Install bearings (28) in gears (32). Install gears (32) and thrust washers (31) in carrier (27).16. Install shafts (29) in thercarrier and the bearings for the ge rs. Install the pins that hold the shafts in the carrier. 17. Turn the carrier over. Install the ring on bearing (35). Install the bearing in the carrier.18. Install ring (33) on the carrier. Put the ring in compression. Install ring gear (31) on the carrier and over the ring. Release the ring to hold the gear.19. Hit pins (30) with a punch and a hammer from the other side to hold the ring gear to the gear on the carrier. 20. Install the ring on cage (36). Install the cage in the bearing for the carrier.21. Put the carrier and ring gear (34) in position over the gears in carrier (9).22. Install the dowels that hold the No.3 and No.4 clutch plates in alignment. 23. Install two discs (38) and one plate (39) starting with a disc. These discs and this plate are for the No.4 clutch.24. Install springs (37) in their correct locations in housing (22). 25. Install the inner and the outer ring seals on pistons (40) and (42). Install piston (42) in housing (41).26. Put housing (41) in position over the dowels and springs. Make sure the springs are in their correct locations in the housing and in piston (42). Install piston (40) in housing (41). 27. Install ring gear (43) over the gears in carrier (27). Install two discs (44) and plate (45) on the piston starting with a disc. These discs and this plate are for the No.5 clutch. 28. Put bearing cage (47) in position over the cage on the center shaft.29. Install bolts (48) that hold the bearing cage to the carrier.30. Install springs (50) in the piston. Install dowels (51) that hold the plates for the No.5 and No.6 clutch in alignment. Put housing (49) in position over the dowels and the springs. Make sure the springs are in their correct locations in the housing. Put gear (46) in position on the center shaft.31. Install the inner and the outer ring seals on piston (54). Install piston (54) in housing (49). 32. Install ring gear (52). Install four discs (53) and three plates (55) on the piston starting with a disc. These discs and plates are for the No.6 clutch. Install the springs in their correct locations in piston (54). 33. Install bearings (60) in gears (58). Install the gears and thrust washers (57) in carrier (56).34. Install