SEAT 9G9201 - Caterpillar

Table 1
Event Codes    
EID    Description of Code    
004     Engine Overspeed Shutdown    
005     Fuel Filter Restriction Derate    
006     Fuel Filter Restriction Shutdown    
015     High Engine Coolant Temperature Derate    
016     High Engine Coolant Temperature Shutdown    
017     High Engine Coolant Temperature Warning    
025     High Inlet Air Temperature Derate    
027     High Inlet Air Temperature Warning    
039     Low Engine Oil Pressure Derate    
040     Low Engine Oil Pressure Shutdown    
054     High Fuel Temperature Derate    
055     High Fuel Temperature Shutdown    
056     High Fuel Temperature Warning    
057     Low Engine Coolant Level Derate    
058     Low Engine Coolant Level Shutdown    
059     Low Engine Coolant Level Warning    
095     Fuel Filter Restriction Warning    
096     High Fuel Pressure    
100     Low Engine Oil Pressure Warning    
190     Engine Overspeed Warning    
443     High Auxiliary Pressure    
445     High Auxiliary Temperature    The Electronic Control Module (ECM) can log events. Events refer to engine operating conditions such as low oil pressure or high coolant temperature. Logged events usually indicate a mechanical problem instead of an electronic system problem.
Illustration 1 g00740986
Output voltage from a typical analog temperature sensor (Coolant temperature sensor shown) Parameters for Programmable Monitoring System
The following features are able to be selected in the monitoring system for industrial engines.
Warning
Derate
ShutdownThe Caterpillar Electronic Technician (ET) can be used in order to select the monitoring features. These features can be turned ON or OFF. When an event is active, the ECM will generate an event code.The ECM will generate an EID diagnostic code on the Cat data link. The diagnostic code will be displayed on a diagnostic screen of Cat ET.The ECM will generate a SPN-FMI diagnostic code on the J1939 data link. The diagnostic code may be displayed on a receiving device for the J1939 data link.The ECM will generate a flash code that will be displayed on the diagnostic lamp.The warning lamp will display the following conditions.
Remain ON for a "Warning".
Flash for a "Derate".When a selected level is turned OFF, the ECM will log the event code but the ECM will not take any action on the event. For example, the ECM will not give a warning, a derate, or a shutdown.If multiple derates are active, the derate that limits the most power will be the derate that is shown.