AVSPARE.COM
parts catalog
  1. Home
  2. Caterpillar catalog

4P1603 SHIELD GP-TURBOCHARGER 3116 TRUCK ENGINE


AIR INLET AND EXHAUST SYSTEM
TURBOCHARGER GP
BASIC ENGINE
AIR COMPRESSOR GP
ELECTRICAL AND STARTING SYSTEM
SOLENOID GP

TRUCK ENGINE 3116 TRUCK ENGINE 3RJ
 3116 ENGINE TRUCK - ATAAC 3RJ00100-UP SEBP2194 3116 3RJ   (1989)

AIR INLET AND EXHAUST SYSTEM

TURBOCHARGER GP
TURBOCHARGER GP
4R-8911 TURBOCHARGER GP
TURBOCHARGER
4R-9147 TURBOCHARGER
TURBOCHARGER GP
4R-8916 TURBOCHARGER GP
TURBOCHARGER GP
4R-8915 TURBOCHARGER GP
LINES GP-TURBOCHARGER OIL
4P-2906 LINES GP-TURBOCHARGER OIL
SHIELD GP-TURBOCHARGER
4P-1603 SHIELD GP-TURBOCHARGER
 

#SEBP21940080
 

4P-1603: SHIELD GP-TURBOCHARGER

4P1603 SHIELD GP-TURBOCHARGER
c943528 SEBP2194
4P1603 SHIELD GP-TURBOCHARGER Parts scheme
  For full view, you need register

Parts for your 3116 TRUCK ENGINE:

CATERPILLAR SIS
Pos. Part No Qty Parts name Comments
1. 4P-2949 [1] SHIELD-HEAT  
2. 8T-4200 M [1] BOLT  
3. 8T-4224 [1] WASHER-HARD  
  M   METRIC PART
 

#SEBP21940081
 

5R-8855: AIR COMPRESSOR DRIVE GP

5R8855 AIR COMPRESSOR DRIVE GP
c943529 SEBP2194
5R8855 AIR COMPRESSOR DRIVE GP Parts scheme
  For full view, you need register

Parts for your 3116 TRUCK ENGINE:

CATERPILLAR SIS
Pos. Part No Qty Parts name Comments
1. 9Y-4634 [1] GASKET-POWER TAKE OFF  
2. 7C-3179 [1] GEAR-AIR COMPRESSOR  
3. 6B-6682 [1] NUT-FULL  
  7X-0521 [1] WASHER-HARD  
 

#SEBP21940082
 

7C-9458: SOLENOID GP-SHUT-OFF

7C9458 SOLENOID GP - SHUT-OFF
24 VOLT
c943530 SEBP2194
7C9458 SOLENOID GP-SHUT-OFF Parts scheme
  For full view, you need register

Parts for your 3116 TRUCK ENGINE:

CATERPILLAR SIS
Pos. Part No Qty Parts name Comments
1. 4K-1388 [1] SEAL-O-RING  
2. 3E-0268 [1] SOLENOID AS  
3. 6V-8377 [2] NUT  
4. 9B-7233 [2] LOCKWASHER  
 

Information:

Truck Engine News
Special Instructions Packaged With Turbocharger Cartridge Repair Kits May Be Incorrect
1986/02/01
New Hose Used To Connect Turbocharger Compressor Outlet To Air To Air Aftercooler (ATAAC) Inlet Tubing
1991/08/01
Service Tips For Effective Repair Of Failed Turbochargers
1993/04/01
A Revised Special Instruction Provides Information on Service Replacement of the Turbocharger (for Turbocharged Engines Only) {1052}
2003/02/01
Policy for the Reuse of the Turbocharger Turbine Housing {1065}
2012/10/26
Policy for Reusing the Turbocharger Turbine Housing {1052, 1065, 7754}
2003/10/01
Prevent the Possibility of Contamination in order to Ensure Longer Life of Turbochargers {1052}
2003/12/01
Improved Locknuts for the High Pressure Turbocharger to Exhaust Manifold Joint Are Available for Certain Truck Engines {1052}
2012/08/30
Magnetic Cover for the Turbocharger Oil Supply Line {1052, 1307}
2006/02/01
Troubleshooting the Wastegate Canister {1052, 1057}
2008/12/01
Engine News
Turbocharger Bearings Are Now Available In More Different Sizes For Better Turbocharger Reconditioning
1979/08/22
Changes To Retainer Nut Torque And Assembly Procedures For Turbocharger Compressor Wheels
1977/03/15
Silicone Grease Now Used In Seal Ring Groove In Turbochargers
1978/05/24
Improved Seal Rings For Turbine End Of Turbochargers
1978/07/05
Salvage Of Turbocharger Compressor Housing During Reconditioning
1978/10/18
Reuse And Salvage Has Updated Air Inlet Correction Factors for Dynamometer Testing {1000, 1052, 1087}
Reuse And Salvage Has Updated Air Inlet Correction Factors for Dynamometer Testing {1000, 1052, 1087}
Special Instruction
Installation of 7C9760 (12V) or 8N3569 (24V) Fuel Boost Pump Group{1250, 1256, 1260}
Installation of 7C9760 (12V) or 8N3569 (24V) Fuel Boost Pump Group{1250, 1256, 1260}
Instructions for the Service Replacement of the Turbochargers{1052}
Instructions for the Service Replacement of the Turbochargers{1052}
Installation Instructions for Turbochargers {1052}
Installation Instructions for Turbochargers {1052}
Proper Remanufactured Turbocharger Housing Adjustment and Alignment for Caterpillar Engines {1052, 1053}
Proper Remanufactured Turbocharger Housing Adjustment and Alignment for Caterpillar Engines {1052, 1053}
Reuse And Salvage Guidelines
Reuse and Salvage for Turbochargers {0760, 0767, 1052}
Reuse and Salvage for Turbochargers {0760, 0767, 1052}
Information Release Memo
APPEARANCE CHANGE ON REMAN SHORT BLOCKS
APPEARANCE CHANGE ON REMAN SHORT BLOCKS
Service Magazine
Caterpillar Recommends Against The Use Of Alcohol Mist Injection Systems{1050,1250}
1982/06/28
Use Care When Handling Turbocharger Compressor Wheels{1052,1077}
1985/12/16
Special Instructions Packaged With Turbocharger Cartridge Repair Kits May Be Incorrect{1053}
1986/02/03
Determining The Cause Of Glow Plug Tip Failures{1053,1105,1412}
1986/06/02
Changes To Retainer Nut Torque And Assembly Procedures For Turbocharger Compressor Wheels{0374,1052}
1977/02/28
Stop Engine If There Is A Turbocharger Bearing Failure{1052,1318}
1987/04/06
Be Sure To Correctly Tighten Turbocharger Clamp Assemblies{1052}
1987/09/07
Silicone Grease Now Used In Seal Ring Groove In Turbochargers{1052,1053,1077}
1978/05/15
Improved Seal Rings For Turbine End Of Turbochargers{1052}
1978/07/03
Salvage Of Turbocharger Compressor Housing During Reconditioning{1052}
1978/10/09
Use Of 9S3265 Retaining Compound On Schwitzer Turbocharger Compressor Wheel Retainer Nuts{1052,1053}
1979/06/25
Turbocharger Bearings Are Now Available In More Different Sizes For Better Turbocharger Reconditioning{1053}
1979/08/20
Only One Dowel Pin Is Now Used To Hold The Thrust Bearing In The Correct Position{1053,1052}
1979/09/03
6V2055 High Vacuum Grease Gives Better Oil Seal {1052,1053,1077,0682}
1979/09/10
Different Thrust Bearing And Thrust Rings Now Used In Turbochargers{1052,1053}
1979/10/22
New Hose Used To Connect Turbocharger Compressor Outlet To Air To Air Aftercooler (ATAAC) Inlet Tubing {1052,1063}
1991/08/26
Service Tips For Effective Repair Of Failed Turbochargers{1052,1063,1059}
1993/05/10
Compressor Nut Torque For Schwitzer Turbochargers{1052}
1993/07/26
Dealer Installed Air Inlet Heater Starting Aid Available{1058}
1993/09/27
New Turbocharger Models Have Left-Hand Threads On Compressor Nut And Turbine Shaft {1053,1052}
1994/02/28
Troubleshooting the Wastegate Canister {1052, 1057}
2008/12/22
Reuse And Salvage Has Updated Air Inlet Correction Factors for Dynamometer Testing {0769, 1052, 1087}
Reuse And Salvage Has Updated Air Inlet Correction Factors for Dynamometer Testing {0769, 1052, 1087}

Caterpillar Parts SIS Catalog 3116 :

LINES GP-TURBOCHARGER OIL
4P-2906 LINES GP-TURBOCHARGER OIL
TURBOCHARGER GP
4R-8915 TURBOCHARGER GP
TURBOCHARGER GP
4R-8916 TURBOCHARGER GP
TURBOCHARGER
4R-9147 TURBOCHARGER
TURBOCHARGER GP
4R-8911 TURBOCHARGER GP
COVER GP - INLET MANIFOLD
5R-8853 COVER GP - INLET MANIFOLD
MANIFOLD GP-INLET
4R-9808 MANIFOLD GP-INLET
MANIFOLD GP-EXHAUST
6I-0919 MANIFOLD GP-EXHAUST
AIR COMPRESSOR DRIVE GP
5R-8855 AIR COMPRESSOR DRIVE GP
SOLENOID GP-SHUT-OFF
7C-9458 SOLENOID GP-SHUT-OFF

Truck sale:

1998 CAT 3116
USD $14,000 
1998 CAT 3116

Milton CAT Power Systems
Milford, Massachusetts
2001 CAT 3116
USD $2,500 
2001 CAT 3116

Foley Equipment Company
Topeka Area, Kansas
 
 
2014 CAT 3116

Yoder & Frey Auctioneers
Ashland, Ohio
1989 CAT 3116
USD $22,500 
1989 CAT 3116

Martin Energy Group LLC
Ephrata, Pennsylvania
1997 CAT 3116
USD $20,997 
1997 CAT 3116

Hewitt Equipment Ltd
QUÉBEC, Quebec, Canada
Back to top
Contacts Request list Affiliate disclosure
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.