OPERATOR STATION
PANEL GPSERVICE EQUIPMENT AND SUPPLIES
CHARTS & FILMSFUEL SYSTEM
GOVERNOR GPSERVICE EQUIPMENT AND SUPPLIES
GASKET & SEAL KITSKIT-REBUILD
OPERATOR STATION
PANEL GP
#SEBP37880260
492-6332: PANEL AS-ELECTRONIC
492-6332 PANEL AS-ELECTRONIC (CHG -00, -01-03 THRU -05)
For full view, you need register
Parts for your 3612 MARINE ENGINE:
CATERPILLAR SIS#SEBP37880261
6L-4502: CHART-PLATE & FILM
6L-4502 CHART-PLATE & FILM (CHG -675)
For full view, you need register
Parts for your 3612 MARINE ENGINE:
CATERPILLAR SIS| Pos. | Part No | Qty | Parts name | Comments |
|---|---|---|---|---|
| [1] | FILM-IDENTIFICATION (CERTIFICATION) | |||
| CONTACT YOUR LOCAL DEALER. | ||||
| INSTALL FILM ON THE RH REAR VALVE COVER, VISIBLE FROM THE SIDE OF THE ENGINE. | ||||
| 7W-3077 | [1] | FILM-IDENTIFICATION (OIL FILTER, LH) | ||
| NOT REQUIRED WITH RH SERVICE: INSTALL FILM ON THE DUPLEX OIL FILTER VALVE ON THE LH SIDE OF THE ENGINE. | ||||
| 7W-3078 | [1] | FILM-IDENTIFICATION (OIL FILTER, RH) | ||
| NOT REQUIRED WITH LH SERVICE: INSTALL FILM ON THE DUPLEX OIL FILTER VALVE ON THE RH SIDE OF THE ENGINE. | ||||
| 7E-0248 | [1] | FILM-INFORMATION (BARRING, READ OMM) | ||
| INSTALL FILM AT THE BOTTOM OF THE MOST REAR CRANKCASE COVER NEAREST THE BARRING DEVICE, | ||||
| VISIBLE FROM THE SIDE OF THE ENGINE. | ||||
| 7W-3055 | [1] | FILM-INFORMATION (CONNECTION) | ||
| INSTALL APPROPRIATE IDENT NUMBER FROM 7W-3055 FILM OVER THE CORRESPONDING NUMBERS FOR THE LINES GROUPS, | ||||
| USE LINES GROUP PRINT FOR REFERENCE. | ||||
| 9Y-9775 | [12] | FILM-INFORMATION (OPEN, MECHANICAL ROTATE) | ||
| INSTALL ONE ON EACH PUSH ROD COMPARTMENT COVER NEAR CYLINDER PRESSURE VALVE LOCATED IN THE CYLINDER HEAD. | ||||
| 7W-5890 | [1] | FILM-INFORMATION (STANDARD ROTATION) | ||
| INSTALL FILM ON THE TOP OF THE FLYWHEEL HOUSING, | ||||
| IF THE HOUSING IS NOT AVAILABLE, INSTALL FILM ON THE REAR CAM GEAR COVER. | ||||
| 7W-5891 | [1] | FILM-INFORMATION (REVERSE ROTATION) | ||
| INSTALL FILM ON THE TOP OF THE FLYWHEEL HOUSING, | ||||
| IF THE HOUSING IS NOT AVAILABLE, INSTALL FILM ON THE REAR CAM GEAR COVER. | ||||
| 7W-3079 | [1] | FILM-INSTRUCTION | ||
| REMOVE PLASTIC FILM BEFORE INSTALLING PLATE. | ||||
| RH SERVICE: INSTALL PLATE ON THE RH SIDE OF THE ENGINE ABOVE THE DUPLEX OIL FILTER SERVICE VALVE. | ||||
| LH SERVICE: INSTALL PLATE ON THE LH SIDE OF THE ENGINE ABOVE THE DUPLEX OIL FILTER SERVICE VALVE. | ||||
| [3] | FILM-INSTRUCTION (TORQUE) | |||
| INSTALL FILM ON THE RH OR LH SIDE OF THE MAINTENANCE INSTRUCTION FILM, ON THE SAME SIDE AS THE CLAMP ASSEMBLY SCREW. | ||||
| [4] | FILM-INSTRUCTION (ENGINE LIFTING INSTRUCTION) | |||
| INSTALL ONE ON EACH LIFTING EYE VISIBLE FROM THE SIDE. | ||||
| 7E-5942 | [3] | FILM-INSTRUCTION (MAINTENANCE) | ||
| APPLY TO CENTRIFUGAL FILTERS. | ||||
| 7W-9787 | [1] | FILM-SERVICE PROCEDURE | ||
| RH SERVICE: INSTALL FILM ON THE RH SIDE OF THE ENGINE ON THE UPPER SERVICE COVER OF THE DUPLEX FUEL FILTER. | ||||
| LH SERVICE: INSTALL FILM ON THE LH SIDE OF THE ENGINE ON THE UPPER SERVICE COVER OF THE DUPLEX FUEL FILTER. | ||||
| 1H-4950 | [2] | FILM-WARNING (CRANKCASE) | ||
| INSTALL ONE FILM ON EACH SIDE OF THE ENGINE, ON THE RH SIDE CENTERED ON THE FIRST VISIBLE CRANKCASE COVER FROM THE | ||||
| REAR, & LH SIDE CENTERED ON THE FIRST VISIBLE CRANKCASE COVER FROM THE FRONT. | ||||
| [4] | FILM-WARNING (LIFTING INSTRUCTIONS) | |||
| INSTALL ONE FILM ON THE TOP OF CYL'S. #1 & #12 VALVE COVERS. | ||||
| 7C-7309 | [4] | FILM-WARNING (LIFTING INSTRUCTIONS) | ||
| INSTALL ONE FILM ON THE TOP OF CYL'S. #3 & #10 VALVE COVERS, | ||||
| IF EITHER OF THESE CYLINDERS HAS A BREATHER INSTALLED MOVE FILM TO THE FIRST AVAILIBLE VALVE COVER. | ||||
| 7W-3076 | [2] | FILM-WARNING (HIGH PRESSURE OIL) | ||
| INSTALL ONE FILM ON THE UPPER & LOWER SERVICE COVER OF THE OIL FILTER HOUSING. | ||||
| 7E-5941 | [3] | FILM-WARNING (FILTER) | ||
| APPLY TO CENTRIFUGAL FILTERS. | ||||
| 107-6352 | [4] | FILM-WARNING (COOLANT DRAIN) | ||
| INSTALL ONE FILM ON EACH COOLANT SYSTEM SHIPPING COVER. USE AS NEEDED. | ||||
| 115-5852 | [1] | PLATE & FILM GP (ENGINE INFORMATION) | ||
| CONTACT YOUR LOCAL DEALER. | ||||
| INSTALL FILM BETWEEN THE LAST TWO CRANKCASE COVERS ON THE RH REAR OF THE CYLINDER BLOCK. | ||||
| INSTALL CLEAR LAMINATE OVER FILM. | ||||
| 298-5631 | [2] | PLATE-IDENTIFICATION (CAT) | ||
| INSTALL ONE PLATE ON EACH SIDE OF THE ENGINE, ON THE FIRST VISIBLE CAM COVER | ||||
| FROM THE RH REAR & THE FIRST VISIBLE CAM COVER FROM LH FRONT. | ||||
| 3N-3790 | [1] | PLATE-SERIAL NUMBER (ENGINE) | ||
| CONTACT YOUR LOCAL DEALER. | ||||
| REFLATTEN AFTER STAMPING. | ||||
| INSTALL ON LH SIDE OF CYLINDER BLOCK BETWEEN REAR TWO CRANKCASE COVERS USING 7B3028 DRIVE SCREWS. | ||||
| STAMP SERIAL NUMBER IN BLOCK JUST BELOW PLATE IN FIGURES 6 HIGH. | ||||
| 7B-3028 | [2] | SCREW-DRIVE (NO 4X 3/16-IN) | ||
#SEBP37880262
352-9860: FILM GP
352-9860 FILM GP -ENGINE (CHG -00)
For full view, you need register
Parts for your 3612 MARINE ENGINE:
CATERPILLAR SIS#SEBP37880263
4C-6710: GOVERNOR TEST UNIT GP
4C-6710 GOVERNOR TEST UNIT GP (CHG -00, -01)
For full view, you need register
Parts for your 3612 MARINE ENGINE:
CATERPILLAR SIS| Pos. | Part No | Qty | Parts name | Comments |
|---|---|---|---|---|
| (NO SERVICED PARTS) | ||||
#SEBP37880264
486-2247: KIT-GASKET
486-2247 KIT-GASKET (CHG -01, -02)
REAR STRUCTURE GASKET KIT
REAR STRUCTURE GASKET KIT
For full view, you need register
Parts for your 3612 MARINE ENGINE:
CATERPILLAR SIS| Pos. | Part No | Qty | Parts name | Comments |
|---|---|---|---|---|
| 1W-3557 | [1] | GASKET | ||
| 4P-0340 | [1] | GASKET | ||
| 4W-6638 | [2] | GASKET | ||
| 4W-9653 | [1] | GASKET | ||
| 8N-8452 | [1] | GASKET | ||
| 116-2480 | [2] | GASKET | ||
| 288-4408 | [1] | GASKET | ||
| 1W-2577 | [2] | GASKET | ||
| 190-2463 | [1] | SEAL AS | ||
| 3P-0649 | [2] | SEAL-O-RING | ||
| 5P-7813 | [2] | SEAL-O-RING | ||
| 6V-3955 | [3] | SEAL-O-RING | ||
| 6V-4589 | [1] | SEAL-O-RING | ||
| 6V-5058 | [1] | SEAL-O-RING | ||
| 6V-5060 | [2] | SEAL-O-RING | ||
| 8C-3103 | [1] | SEAL-O-RING | ||
| 214-7568 | [4] | SEAL-O-RING | ||
| 5P-5846 | [2] | SEAL-O-RING | ||
| 5P-7701 | [1] | SEAL-O-RING | ||
| 6V-8002 | [1] | SEAL-O-RING | ||
| FOR A LIST OF RELATED PARTS THAT MAY BE REQUIRED FOR THE ENGINE REBUILD TO THE KIT CONSIST, PLEASE VISIT | ||||
| HTTP://DEALER.CAT.COM/RELATED | ||||
#SEBP37880265
261-8323: KIT-PARTS
261-8323 KIT-PARTS (CHG -00)
For full view, you need register
Parts for your 3612 MARINE ENGINE:
CATERPILLAR SISInformation:
OPERATOR STATION
PANEL GP
Engine News
New CAT Inspect Form Available for EMCP Troubleshooting and Inspection {0374, 4490, 7451, 7620}
New CAT Inspect Form Available for EMCP Troubleshooting and Inspection {0374, 4490, 7451, 7620}
New CAT Inspect Form Available for EMCP Troubleshooting and Inspection {0374, 4490, 7451, 7620}
Special Instruction
Instructions for Installing AssetIQ<SUP>TM</SUP> for Engine Systems on Caterpillar and non-Caterpillar Products {7490}
Instructions for Installing AssetIQTM for Engine Systems on Caterpillar and non-Caterpillar Products {7490}
Instructions for Installing AssetIQTM for Engine Systems on Caterpillar and non-Caterpillar Products {7490}
Service Magazine