SEGMENT-SPROCKET 1061609 - Caterpillar

Working with Dialogs
The "system installation", "vertical setup", "horizontal offset" selection, "vertical offset" selection, "design selection", and the "Setup Menu - Configuration" option screens are called dialogs. Use dialogs in order to enter data. Use the dialogs in order for the AccuGrade System to be set up according to your requirements. The selected field in a dialog is identified by the blue background color.Press the "Next" Key (4) on the display in order to move to different fields within the dialogs.Press the Arrow Keys (9) on the Display in order to enter data:The up arrow steps through the upper case letters "A through Z", the numbers "0 through 9", the decimal point ".", the negative sign "–", the positive sign "+", a space, and back to "A".Note: Available values will depend on the type of field that is selected. For example, the only values that are available for number fields are 0 through 9, the decimal point ".", "–", and "+".The down arrow steps through the same character set, but in reverse.When you change a character in a field, the up arrow and the down arrow start stepping from the existing character.The right arrow steps to the next character to the right. In fields that allow spaces, press the right arrow twice in order to insert a space.The left arrow is used in order to move back one character to the left. This deletes the character in the space to the left.Dialogs may contain any of the following items:Text fields - Use the text fields in order to enter your own information. For example, when you set up the name of your level surface design or sloping surface design, use the Arrow Keys (8) in order to enter this data.Number fields - Use the number fields in order to enter required values. For example, when you set up the vertical and horizontal offset, use the Arrow Keys (9) in order to enter values into these fields. List boxes - Lists options or possible selections. Use the Arrow Keys (9) in order to select the listed item.Warnings
An error such as the loss of GPS data will cause inaccurate guidance. When an error occurs, a warning message flashes on the screen. Light Bar guidance is not provided under these conditions. For more information, Refer to Operation and Maintenance Manual, "Flashing Warning Messages".The "Check Bucket Sensor" warning appears when the receiver has stopped outputting data for at least 1.5 seconds. Refer to Illustration 3.
Illustration 3 g01780416
Hourglass
When the system performs an operation that takes more than a few seconds, an hourglass appears on the current screen. For example, the hourglass appears in the following situations:
The hourglass appears in the "Plan View", the "Cross Section View", or the "Profile View", while the software updates the display after a pan or zoom.
The hourglass will appear in the "Select Design File" dialog while a design is being loaded from the Data Card.The following dialog shows the hourglass while the AccuGrade System loads a design file:
Illustration 4 g01266533
Guidance Status