SENDER AS 1578850 - Caterpillar

Illustration 4 g01470042
Remove bolts (4) and position fan (5) into the fan shroud, as shown.
Illustration 5 g01469824
Remove belt (9) from the refrigerant compressor. Refer to Operation and Maintenance Manual, "Belts - Inspect/Adjust/Replace".
Remove bolt (6) and clamps (7). Disconnect harness assembly (8) .
Remove bolts (10) and position refrigerant compressor (11) to one side.
Illustration 6 g01474332
Disconnect clips (12), (13), and (14) .
Illustration 7 g01474335
Disconnect two clips (15) .
Illustration 8 g01474353
Disconnect clips (16) and (17) .
Illustration 9 g01474374
Position hose assemblies (18), refrigerant receiver-dryer (19), and refrigerant compressor (11) to one side, as shown.
Illustration 10 g01474435
Cut cable strap (21). Disconnect clip (24). Position harness assembly (22) to one side.
Disconnect hose assembly (20) from clip (23). Position hose assembly (20) to one side.
Illustration 11 g01474444
Remove bolts (26) and disconnect bracket assembly (25) .
Illustration 12 g01474446
Disconnect lower radiator hose (27) .
Illustration 13 g01474451
Disconnect clip (28). Disconnect hydraulic lower oil cooler tube (29) .
Illustration 14 g01474452
Disconnect upper hydraulic oil cooler tube (30) .
Illustration 15 g01474459
Attach Tooling (A) and a suitable lifting device to radiator and hydraulic oil cooler (31). The weight of radiator and hydraulic oil cooler (31) is approximately 34 kg (75 lb).
Illustration 16 g01474462
Remove bolts (32) from radiator and hydraulic oil cooler (31). Repeat for the other side.
Illustration 17 g01474464
Remove six bolts (33) from the rear side of radiator and hydraulic cooler (31) .
Illustration 18 g01477457
Remove the radiator and hydraulic cooler (31) .