SENDER GP-FUEL LEVEL 2400634 - Caterpillar

Removal Procedure
Table 1
Required Tooling
Tool Part Number Part Description Qty
A FT-2674 Vacuum Cap 1
B 525-5184 Hydraulic Jack 1 Start By:
Connect the steering frame lock.
Release the hydraulic system pressure.
Illustration 1 g02722636
Remove the breather from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
Illustration 2 g06217170
Position Tooling (B) under guard (1). The weight of guard (1) is approximately 43 kg (95 lb). Remove the bolts and use Tooling (B) to remove guard (1) from the machine.
Illustration 3 g02843797
Disconnect hose assemblies (2).
Disconnect harness assembly (3) (not shown) from the solenoid valve.
Remove the bolts and remove differential lock control valve (4) from the machine.Installation Procedure
Install differential lock control valve (4) in the reverse order of removal.Disassembly Procedure
Start By:
Remove the differential lock control valve.
Illustration 4 g01391125
Remove bolts (2) and solenoid valve (1).
Illustration 5 g01391126
Remove O-ring seals (3) from solenoid valve (1).Assembly Procedure
Illustration 6 g01391126
Install O-ring seals (3) to solenoid valve (1).
Illustration 7 g01391125
Install solenoid valve (1) and bolts (2). Tighten bolts (2) to a torque of 3.5 0.5 N m (30.98 4.43 lb in).End By:
Install the differential lock control valve.