AVSPARE.COM
parts catalog
  1. Home
  2. Caterpillar SIS
  3. SENDER
  4. 2895782

SENDER AS-FUEL LEVEL 2895782 - Caterpillar


2895782 SENDER AS-FUEL LEVEL Caterpillar parts 303.5C, 303.5D, 303C CR, 303E CR, 304D CR


Price: query
Add in request price Go to cart
Rating:
15
Alternative (cross code) number:
CA2895782
289-5782
2895782
Caterpillar 2895782 SENDER AS-FUEL LEVEL
Weight: 1 pounds 0 kg.

Buy SENDER AS-FUEL LEVEL 2895782 Caterpillar genuine, new aftermarket tractor parts with delivery
MINI HYD EXCAVATOR,

This part in 5 request: Show. This information for suppliers only!
#1483127 2895782
2025-01-14
#1443782 2895782
2024-10-20
#1139572 2895782
2023-06-08
#1041332 2895782
2023-01-17
#877797 2895782
2022-05-06

Compatible equipment models: 2895782:

MINI HYD EXCAVATOR  303.5C   303.5D   303C CR   303E CR   304D CR   Caterpillar
Number on catalog scheme: 15
Caterpillar 2895782 Parts scheme SENDER AS-FUEL LEVEL
  For full view, you need register

Information:


Illustration 1 g01377175
Right front drive pump forward control solenoid circuitThis diagnostic code is associated with the right front drive pump forward control solenoid (all wheel drive). The FMI 13 diagnostic code is activated when the all wheel drive (AWD) ECM detects the right front drive pump forward solenoid that needs calibration. Once the calibration for the right front drive pump forward control solenoid has been performed successfully, this diagnostic code will disappear. This failure is active on a new ECM.Possible causes of this diagnostic code are listed below:
The ECM has been replaced or new software has been installed.
The ECM has failed.System Response:The machine response is listed below:
AWD will not operate.Note: Ensure that you have repaired any condition that would cause other active diagnostic codes that are related to this solenoid. If the other diagnostic codes are active, troubleshoot those codes first. Then perform this procedure.Note: Ensure that the diagnostic code of CID 2297 FMI 13 is active before performing this procedure.Test Step 1. CHECK THE CALIBRATION
Perform the necessary adjustment and calibration procedures. Perform the calibration with Cat ET. See the Testing and Adjusting Section of the Service Manual for these procedures.
Observe the status of the CID 2297 FMI 13.Expected Result:CID 2297 FMI 13 is not active.Results:
OK - CID 2297 FMI 13 is not active. Calibration corrected the condition that caused the CID 2297 FMI 13. Resume normal operation.STOP
NOT OK - The CID 2297 FMI 13 is active. Repair: Verify that the correct software has been flashed into the ECM, and the correct ECM is installed on the machine. Then repeat the calibration. If the diagnostic code remains active, verify that the sensor and associated circuits are correct. If the cause of the diagnostic code is not found, contact the Technical Communicator at your Cat® dealer. If ECM replacement is required, see Troubleshooting, "Electronic Control Module (ECM) - Replace".STOP

Caterpillar parts catalog:

Caterpillar parts catalog
303ECR Mini Hydraulic Excavator CK300001-UP (MACHINE) POWERED BY C1.3 Engine
304D CR Mini Excavator TYK00001-UP (MACHINE) POWERED BY S3Q2 Engine
303.5C CR Mini Hydraulic Excavator DMY00001-UP (MACHINE) POWERED BY S3Q2 Engine
303C CR Mini Hydraulic Excavator BXT00001-UP (MACHINE) POWERED BY S3Q2 Engine
303.5 D Mini Excavator RHP00001-UP (MACHINE) POWERED BY S3Q2 Engine
303E CR Mini Hydraulic Excavator SMG00001-UP (MACHINE) POWERED BY C1.3 Engine
303E CR Mini Hydraulic Excavator CR700001-UP (MACHINE) POWERED BY C1.3 Engine
303E CR Mini Hydraulic Excavator HHM00001-UP (MACHINE) POWERED BY C1.3 Engine
303E CR Mini Hydraulic Excavator SGE00001-UP (MACHINE) POWERED BY C1.3 Engine


Parts sender Caterpillar catalog:

2803754 SENDER-WATER TEMPERATURE
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5, 305.5D, 305C CR, 305D CR, 306
2895779 SENDER AS-FUEL LEVEL
303C CR
2803754 SENDER-WATER TEMPERATURE
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5, 305.5D, 305C CR, 305D CR, 306
3411842 SENDER AS-FUEL LEVEL
2290, 2390, 2391, 2491, 2590, 312C, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 315D L, 316E L, 318D L, 318D2 L, 318E L, 319D L, 319D LN, 320C FM, 320D, 320D FM, 320D...
2478354 SENDER AS
308C, 314C
3422924 SENDER AS-TEMPERATURE
307C, 307D, 308D, 308E, 308E CR, 308E SR, 308E2 CR, 311D LRR, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314D CR, 314D LCR, 314E CR, 314E LCR, 315D L, 316E L, 318D L...
3413685 SENDER AS-FUEL LEVEL
2384C, 2484C, 306, 306E, 307C, 307D, 320B, 320C, 320D FM RR, 320D LRR, 320D RR, 322B L, 330B L, 345B II, 345B II MH, 559C, 579C, W330B, W345B II
1905769 SENDER AS-TEMPERATURE
305.5, 306, 307C, 307D, 308D
4503704 SENDER AS-FUEL LEVEL
302.7D
4503706 SENDER AS-FUEL LEVEL
301.4C
3755025 SENDER AS-FUEL LEVEL
301.4C
2666934 SENDER AS-FUEL LEVEL
304C CR, 305.5D, 305C CR, 305D CR
2895779 SENDER AS-FUEL LEVEL
303C CR
2498574 SENDER GP-FUEL LEVEL
302.5C
2895782
Back to top
Contacts Request list Affiliate disclosure
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.