SENDER AS-PRESSURE 2950759 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the installation of new components due to normal wear and aging. The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption , mileage , service hours and calendar time . Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Storage Procedure - Check
Fuel System - Prime
Severe Service Application - Check
Daily
Cooling System Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Power Take-Off Clutch - Check/Adjust/Lubricate
Walk-Around Inspection
Every Week
Battery Charger - Check
Engine Air Precleaner - Check/Clean
Fuel Tank Water and Sediment - Drain
Jacket Water Heater - Check
Every 250 Service Hours
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil and Filter - Change
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Belts - Inspect/Adjust/Replace
Cooling System Coolant Sample (Level 1) - Obtain
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 500 Service Hours or 6 Months
Engine Protective Devices - Check
Every 2000 Service Hours or 1 Year
Alternator - Inspect
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 3 Years
Cooling System Coolant (DEAC) - Change
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
Every 14 400 L (3750 US gal) of Fuel or 250 Service Hours or 1 Year
Battery Electrolyte Level - Check
Electronics Grounding Stud - Inspect/Clean/Tighten
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 28 500 L (7500 US gal) of Fuel or 500 Service Hours or 1 Year (Deep Sump)
Engine Oil and Filter - Change
Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours
Aftercooler Core - Clean/Test
Aftercooler Core - Inspect
Every 170 400 L (45 000 US gal) of Fuel or 3000 Service Hours
Air Compressor - Inspect
Crankshaft Vibration Damper - Inspect
Electronic Unit Injector - Inspect/Adjust
Engine - Clean
Engine Mounts - Inspect