SENDER AS-LEVEL 3644015 - Caterpillar

Removal Procedure
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Release the hydraulic system pressure.
Illustration 1 g06206119
Disconnect hose assemblies (1) from right side tilt cylinder (2). Position hose assemblies (1) out of the way.
Illustration 2 g06206198
Attach a suitable lifting device to right side tilt cylinder (2). The weight of tilt cylinder (2) is approximately 16 kg (35 lb).
Remove the bolt and pin assembly (3). Remove the bolt and pin assembly (4). Remove right side tilt cylinder (2).
Repeat Step 2 through Step 4 for the left side tilt cylinder.Installation Procedure
Install tilt cylinder (2) in the reverse order of removal.Disassembly and Assembly Information
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0510 Driver Gp 1
When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Illustration 3 g06206260
(1) Elbow adapter.
(2) Cylinder assembly.
(3) Rod assembly.
Use Tooling (A) to remove bearing sleeve (4) and bearing sleeve (8).
Tighten piston nut (5) to a torque of 908 33 N m (670 24 lb ft).
(6) Piston.
Tighten head (7) to a torque of 440 33 N m (325 24 lb ft).