SENDER AS-FUEL LEVEL 9X4941 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
Reports have been received that the bucket cylinder piston may loosen on the machines listed above. Due to this issue, the cylinder may seize or drift, and damage the cylinder assembly. Metal contamination created by such failure could also damage the components such as seals, control relief valves, and cylinders.Solution
In the event of failure, refer to the following rework procedure:
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Rework Procedure
Illustration 1 g06361337
Bucket cylinder piston
(A) Set screws
Tighten the two set screws (A) to a torque of 30 7 N m (265 62 lb in).
Illustration 2 g06361339
Bucket cylinder piston
Illustration 3 g06361340
Detailed view of area B
(C) Marking location
(D) Screw hole
Illustration 4 g06361342
(A) Set screws
(C) Marking location
(E) Punch tool
Use the punch tool (E) to mark on both edges of each set screw holes (D). Refer to Illustrations 3 and 4.