SENSOR GP 1109735 - Caterpillar

Installation Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Apply a thin coat of 1P-0808 Multipurpose Grease on pin (12) .
Illustration 1 g00702551
Position the head end of the boom cylinder in order to align the bores of the swing frame.
Insert pin (12) .
Install the bolt (10) and the washer (11) in order to secure the pin (12) to the swing frame.
Illustration 2 g00702554
Apply a thin coat of 1P-0808 Multipurpose Grease on pin (9) .
Align the rod end of the boom cylinder with the bores on the boom.
Install pin (9) .
Install the bolt (7) and the washer (8) in order to secure the pin (9) to the boom.
Illustration 3 g00702549
Connect hose assembly (6) to the right side of the boom cylinder.
Illustration 4 g00702548
Connect the hose clamp (4) to the boom cylinder so hose assembly (5) is held in place on the left side of the boom cylinder.
Connect hose assembly (5) to the left side of the boom cylinder.
Illustration 5 g00702543
Install cover (1) with two bolts (2) and two washers (3) .