SENSOR GP-PRESSURE 1305173 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
(M8 by 100 mm) 4
B - Loctite 5900 -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g02701596
Install Tooling (A) to Positions (X) in the cylinder block.
Illustration 2 g02701560
Illustration 3 g02701616
Engine oil pan tightening sequence
Ensure that engine oil pan (7) is clean and free from damage.
Position a new gasket (4) onto engine oil pan (7).
Align the assembly of engine oil pan (7) with Tooling (A).
Install bolts (8) to engine oil pan (7) finger tight.
Install new bolts (9) to engine oil pan (7) in Position (Y) hand tight.
Remove Tooling (A).
Install remaining bolts (8).
Tighten bolts (8) and bolts (9) to a torque of 22 N m (195 lb in). Tighten the bolts in the sequence that is shown in Illustration 3.
Install a new O-ring seal (6) to drain plug (5). Install drain plug (5) to engine oil pan (7). Refer to Illustration 2. Tighten the oil drain plug to a torque of 34 N m (301 lb in).
Illustration 4 g02701559
If necessary, follow Steps 11.a through 11.c in order to install the assembly of the dipstick tube.
Install a new seal (3) to tube assembly (2).
Apply Tooling (B) to nut (1). Install the tube assembly to the engine oil pan. Note: Ensure that the orientation of the tube assembly is correct.
Tighten nut (1) to a torque of 18 N m (159 lb in). Install the dipstick.
Fill the engine oil pan to the correct level. Refer to Operation and Maintenance Manual, "Oil Filter Change" for the procedure.