SENSOR GP-POSITION 1761609 - Caterpillar

28. Apply clean hydraulic oil on the lip of lip seal (38). Install shaft assembly (34) in the travel motor body with a press. Rotate the shaft slowly during installation, making sure it does not bind. Make sure the bearing on the shaft makes contact with the counterbore in the body.
Locating pin (32) (not shown) on each key (31) is not centered. To prevent damage to barrel assembly (23) during assembly of the travel motor, the keys must be installed as shown in the illustration. Also, the keys must be installed in their original locations in the travel motor body.
29. Install the two locating pins and two keys (31) in the travel motor body as shown. 30. Install cam plate (30) in the travel motor body in its original position. Make sure the two pistons and two keys (31) in the travel motor body engage properly with the cam plate. 31. Install nine springs (29) in the barrel. Install spacer (28) and guide (27) on the barrel. 32. Install piston shoe assemblies (25) in their original bores in shoe retainer (24).33. Apply clean hydraulic oil in the bores of the barrel and on piston shoe assemblies (25). Install the piston shoe assemblies with the shoe retainer in their original bores in barrel (26).
Prior to installing barrel assembly (23), make sure cam plate (30) is correctly engaged with the two pistons in the travel motor body. When the travel motor body is tilted to allow installation of barrel assembly (23), cam plate (30) can slide off of the two pistons. The remaining parts of the travel motor can be assembled with the cam plate out of position, however extensive parts damaged will result. Use the procedure in Steps 34 and 35 to prevent parts damage.
34. Apply clean hydraulic oil on the sliding surfaces of the cam plate, the piston shoe assemblies and on the splined shaft of the travel motor. 35. Route a piece of strong string through one of the openings for the cam plate tension adjusters, over the sliding surface of cam plate (30), and out the other opening for the cam plate tension adjusters. Hold the string tight to keep cam plate (30) properly engaged with keys (31). While keeping the string tight, put the travel motor body on its side. Do not release the tension on the string at this time. Install barrel assembly (23) on the shaft as a unit. Pull the string out of the travel motor body. It may be necessary to pull the barrel assembly and piston shoe assemblies away from the cam plate a small amount to release the string. 36. Check the condition of the O-ring seal and the back-up ring used on piston guide (19). If the seal or ring are worn or damaged, use new parts for replacement. Install O-ring seal (21) and back-up ring (22) on piston guide (19) as shown. 37. Put the travel motor body in a vertical position.38. Apply clean hydraulic oil on