SENSOR GP-SPEED 1918304 - Caterpillar

Connection Of Engine And Generator
1. Put fan (6) in position in the generator housing. Make sure holes (12) are toward the outside as shown.2. Install a 1/2" - 10 NC x 4" guide bolt (13) in the generator hub. 3. Install plates (10) on the hub. Remove guide bolt (13) and install the bolts that hold the shims and plates in position.4. Install a 5/8" - 11 NC x 4" guide bolt in the flywheel.
Typical Example5. Install straps as shown and fasten a hoist. Put the generator in position on the generator mounts and install bolts (12). 6. Install tool (B) on the engine and put the engine in position. Use tool (C), if necessary, to rotate the flywheel and put the guide bolt in the flywheel in alignment with the holes in the plates (10) and fan (6).7. Install bolts (7) that hold the generator housing to the flywheel housing.8. Install bolts (8) to the engine front mounts. 9. Remove guide bolt from the flywheel and install bolts (5). 10. Remove the piece of cardboard between stator (3) and rotor assembly (4). 11. Install guard (1) and bolts (2).12. Remove tool (A), tool (B), and tool (C).End By:a. install starterb. install control panel enclosurec. install radiator