SENSOR AS 2007475 - Caterpillar

Removal Procedure
Start By:
Remove the rear chassis support. Refer to Disassembly and Assembly, "Rear Chassis Support - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before you begin the removal procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all hose assemblies and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Illustration 1 g01411099
Disconnect hose assemblies (1) .
Illustration 2 g01411112
Disconnect hose assembly (2), hose assembly (3), and hose assembly (4) .
Disconnect fitting (5) .
Disconnect tube assemblies (6) .
Illustration 3 g01411123
Disconnect tube assemblies (7). Disconnect hose assemblies (8) .
Illustration 4 g01411162
Attach suitable lifting devices to all wheel drive piston pump (9). The weight of all wheel drive piston pump (9) is approximately 111 kg (245 lb).
Remove bolts (10). Remove clips (11) .
Use the suitable lifting devices in order to remove all wheel drive piston pump (9) from the machine.